How to install a harmonic balancer on dodge 4.7 motor
Вставка
- Опубліковано 28 тра 2017
- I didnt see to many helpful videos so i put one up of my 02 Ram 4.7
It was too easy but still some mau question how to install one. Many would just used the harmonic balancer bolt with impact. You can strip the crankshaft threads and then what? So rent a special tool from an auto parts store and geuss what? Not only will you have done the job right, you get your money back.
Tools needed -
harmonic balancer install tool, crescent wrench, 1 socket with ratchet. (Socket may very in size. The one i used was a 17mm) and engine assembly lube.
Thanks for the video fella!! I'm doing the same job, thanks for the heads up, Keep up the videos man!! Have a Blessed day, hope everything went well with your install
Thank you for the video
How can you over tighten it ? I torque it 130 now rubbing on water pump bolts
Thanks for making the video, very helpful!! In your other video the block looked really rusty in the cylinders, what did you do to remedy that?
Sujeir Bowie , lucky for me it was just lite rust. but i used ospho then lacquer thinner to clean residual chemical from ospho and to keep it from rusting up again till i got the heads on, i used tranny fluid on a lint free cloth and wipe the cylinder down . thanks for your kind comment. and my 4.7 is running great.
What tool did you use
hey i live in texas how much is a estimate on fixing a crankshaft pulley or harmonic balancer ?
I'm sorry I wouldn't know that . Prices are different here in Florida. To replace it itll cost $600 to $1200 here . Depending on where you go. If the got the right tool they can pull it without pulling the radiator like you would have to with this tool
Would have been nice if you gave the part number.
Also,you said you got it at advance auto first and at the end you said autozone.
It was definitely autozone. I'll remember to include the part number next time. Thanks for watching
I found the tool.
@ autozone
part # 27306 ...
Side note
It does not fit a 2004 Chrysler Sebring 2.7.
(That is what I'm working on)
@@im234life
No problem, thanks for posting the vid.
do you have a video on how you pulled it out
natesikksevenone this is all i have. Its tough to hold phone and work at the same time. But im getting new camera set up soon!
Issac Moreno did you use the 3 prong puller to take out the harmonic blancer?
natesikksevenone no i did not. This tool i used to pull and install .