Radiator NOT GETTING HOT Because of Blockage in the Pipework. Finding & Removing Blockage. FIXED

Поділитися
Вставка
  • Опубліковано 28 гру 2024

КОМЕНТАРІ •

  • @Chatterisdotbiz
    @Chatterisdotbiz Рік тому +2

    Perfect job for a thermal imaging camera, Black Friday is coming up 😊

  • @littlefortress2221
    @littlefortress2221 10 місяців тому

    Thanks to your very informative videos we've fixed our blocked pipes and now have a boiling hot new radiator 😊👍 thank you very much, keep up the good work.

  • @johnf3326
    @johnf3326 Рік тому +1

    Well done Sherlock! That can't have been cheap for the customer though.
    Those towel rails don't give off much heat anyway, especially when covered in towels!

  • @darrenphillips5874
    @darrenphillips5874 Рік тому +1

    Once had a bending spring in a 22 mm bend , worked fine for the first few years, once it had corroded up system was fubar

  • @garys8983
    @garys8983 Рік тому +3

    My money is on the raw plug being with the connector in tool box, either way they should not have left without radiator getting hot.

    • @normanboyes4983
      @normanboyes4983 Рік тому +4

      Most plumbers get twitched once it gets to 3pm.😊

  • @Benzknees
    @Benzknees Рік тому +1

    You say that the system should be flushed before installing a new boiler. What if you have a single pipe system, so it's impossible to flush the rads?

    • @MarkBallardLTDHeatingEngineer
      @MarkBallardLTDHeatingEngineer  Рік тому +1

      They are a problem. You cant flush. Best to start again, new system

    • @Benzknees
      @Benzknees Рік тому

      @@MarkBallardLTDHeatingEngineer - If stuck down floor coverings mean you can't take up floors and have to stick with a one pipe system, would it be best to use a low loss header or just rely on a mag filter to protect the new boiler?

  • @davidplanet3919
    @davidplanet3919 Рік тому +1

    It’s lucky the plug was trapped in the plastic elbow joint.

  • @andrewhayes4914
    @andrewhayes4914 Рік тому

    I bet he had the plugs in his pockets, I've seen 10mm pipe sleeves trapped in a pump before 😂

  • @3george136
    @3george136 Рік тому +5

    so why wasn't the bathroom fitter called back to fix this / or why wasn't it checked properly once installed - poor form by the homeowner / bathroom fitter IMO.