Loosen the reg lockdown knobs on top, turn the registration knob on the RIGHT side of print head (left/right axis) until the left side of edge of print head lines up with the white line that says 'neutral'. For the up/down, I turn the back reg knobs evenly all the way in (clockwise) and note how many threads are showing. Then turn them all the way out (counter-clockwise). Now turn them to about the middle of that range so both show the same amount of threads. You are now zero'ed. I like to mark the edge of print head with a sharpie, or tape right when you get it zero'ed. That way you know where the center (zero) is.
Hi I finally got my machine. I was wondering if you can make a video on how to adjust off contact. When I put my screen down it is way to high from the back. Please help!
Thanks for these videos!!
Can you make a video about pricing t shirts?
I will look into doing that!
How do you handle waste from the process? That's been my only hitch, especially because I have a septic tank and I use well water.
How do you Zero out the machine?
Loosen the reg lockdown knobs on top, turn the registration knob on the RIGHT side of print head (left/right axis) until the left side of edge of print head lines up with the white line that says 'neutral'. For the up/down, I turn the back reg knobs evenly all the way in (clockwise) and note how many threads are showing. Then turn them all the way out (counter-clockwise). Now turn them to about the middle of that range so both show the same amount of threads. You are now zero'ed. I like to mark the edge of print head with a sharpie, or tape right when you get it zero'ed. That way you know where the center (zero) is.
@@atomicprintdude256 I just got mine shipped. Can you make a video of it?
@@brianpulido8404 Done!
@@atomicprintdude256 thank you, this was helpful!
@@atomicprintdude256 Thank you!
Hi I finally got my machine. I was wondering if you can make a video on how to adjust off contact. When I put my screen down it is way to high from the back. Please help!