etrailer | Yakima ShowDown Kayak or SUP Carrier and Lift Assist Review
Вставка
- Опубліковано 26 сер 2024
- Click for more info and reviews of this Yakima Watersport Carriers:
www.etrailer.c...
Check out some similar Watersport Carriers options:
www.etrailer.c...
www.etrailer.com
Don’t forget to subscribe!
/ etrailertv
Full transcript: www.etrailer.c...
Speaker 1: Today we're going to be taking a look at Yakima ShowDown Kayak or Stand Up Paddle Board Carrier with Lift Assist, part number Y04081. The Yakima ShowDown is great for holding up to kayak or two stand up paddle boards and transporting them safely on your roof. It comes with bow and stern tie-downs for your kayak, as well as two straps to hold your kayak and your stand up paddle boards in place on the rack itself.The biggest feature about this kayak carrier is going to be its lift assist ability. It's very easy to use. You simply remove the pins on either side. This is going to make loading and unloading much easier.
And don't forget to fold in your mirror just to make sure it doesn't get damaged once you lower this down. It's very easy. You just grab the two handles on either side, pull out, and it's ready to unhook and come off, or if you're ready to put it back up, it makes loading it up a snap as well.It has felt-covered pads here, and that's going to protect the finish on your boat as well as your stand up paddle boards, and prevent scratching. The bow and stern tie-downs also come with this plastic sheath to protect your vehicle once it's installed, so it doesn't rub up against the finish. Now, while we have this on aero bars right now, this will work with square, round, elliptical, and most factory-style roof racks as well.
It comes with a knock-out here, both at the rear and at front, which you can replace with the Yakima Same Key System Core, so both your roof rack and your roof accessories can be keyed alike.When comparing this to other kayak carriers, one that comes up is going to be the Thule Hullavator Pro Kayak Carrier with Lift Assist in Tie-Downs, part number TH898. Now, while both these come with the tie-downs necessary to strap your kayak to the roof of your vehicle, there are a few differences. For example, the Thule Hullavator does come with gas struts, which act as a lift assist to push this back up against your vehicle. The Thule Hullavator is a little bit heavier when putting it onto your roof rack, while the Yakima ShowDown is much lighter.The ShowDown is designed to work with the stand up paddle boards in addition to kayaks, while the Hullavator is just designed for kayaks. The Yakima ShowDown is also going to save you some money over the Thule Hullavator.
Now that we've gone over the features of the ShowDown, let's go ahead and show you how it installs. We have one arm already installed on our roof rack system. Here's the second arm. And here's everything that's going to be coming in the kit with this ShowDown.We have two pads here, and that's going to be if you're going to be using it for the stand up paddle board configuration. Then we have two tie-down straps with rubber protectors, to protect the hull and your stand up paddle board.
And then we have four adapters if you're using the round bars. And then we have the kit for our bow and stern tie-downs. Important note I'd like to point out here is that you at least want a space of about three and half inches from the edge of our bar to the edge of our tower.Also, our arms are marked left and right. You can see it on the inside here. Just be sure to put that on the proper side. We make sure that our clamps are in the open position and place it on our bar, like so. We'll to keep it even with our front bar. And then we can start tightening it down. Once you have it tightened down, just give it a quick shake test to make sure it's going to stay in place. Now we can remove the pins on either side and bring our arms out. Pull out and down. And then fold out, holders for our kayak.Now, with it in this open position, you do want to make sure that it's at least four inches away from the vehicle. It looks like we've surpassed that. Before we install a kayak, we are going to move our mirror the inside here, because you don't want the kayak making contact with that as we load it up. Next we're going to start loading up our straps before we put our kayak into place. We'll thread it through this top portion here like so, making sure the portion with the buckle is facing out.Now we can lift our kayak up into place. You can already tell how much easier it is setting into place this way as opposed to having to push it up onto a J-hook or some other configuration. When it's setting into this point, you want to make sure that it's going to be setting evenly on both sides and not more towards one side or the other. Now, to adjust our pads here, we have these knobs at the top
I currently drive a 2018 Chevrolet Traverse which came with factory installed rail and cross bars. I have 2 kayaks both about 26 inches at widest point. Can I install 2 Yakima showdowns one each side so I could carry 2 kayaks or is there something else I should be looking at like the Hullivator? Appreciate your thoughts
How long are your crossbars?