FJ Cruiser Volt Meter + USB Charge Outlets Ports After Market Charger add a circuit

Поділитися
Вставка
  • Опубліковано 29 жов 2024

КОМЕНТАРІ • 42

  • @noraque1336
    @noraque1336 7 років тому +4

    Fantastic! Fantastic!! Fantastic!!! You just saved me a couple hours of work by showing me your installation methods.

    • @cbatilo
      @cbatilo  7 років тому

      Nora Que thank you so much for the feedback. I hope you check the rest of the how to on the description (remove faceplate and wiring). Happy it helped. Good luck with your project and thank you again!

  • @hellogoodbye.
    @hellogoodbye. 8 років тому +1

    Thanx your videos are the closest to what I need help with. I'm installing usb chargers in my XB 2015.

  • @vexelworrior
    @vexelworrior 3 роки тому

    How did you attach the negative wire? Did you connected it to a screw

  • @prophetseven728
    @prophetseven728 3 роки тому

    Thanks for all your Videos. How would you go about fixing Hazard Lights. Mine for some reason will not turn off! I had to pull the Fuse on it. But that shut off my turn singles too!

    • @cbatilo
      @cbatilo  3 роки тому +1

      Did you test your switch - continuity testing. Pull the switch make sure it break continuity when you turn the switch off. If switch is ok.. look at flasher relay.

    • @prophetseven728
      @prophetseven728 3 роки тому

      @@cbatilo Where is the Flasher Relay. Trying to find where I can buy a 2013 FJ Repair Manual. For Wiring etc.. It like looking for a Unicorn.

    • @prophetseven728
      @prophetseven728 3 роки тому

      @@cbatilo I think I got it wet. So Read that I can wash the FJ Cruiser inside with a hose. So I did. Should not aimed it at the Front Dash. LoL. Should keep it on the flooring. Now Im paying for my dumb mistake. Get a new Toy and break it.

    • @prophetseven728
      @prophetseven728 3 роки тому

      @@cbatilo this it? ua-cam.com/video/IMhFlYujw8c/v-deo.html

  • @Hasithaabhayakeerthi
    @Hasithaabhayakeerthi 6 років тому

    Hopefully you see this comment
    Does it draw up lot of current in other words amps ? If so we should add a cut out right?

  • @rickyboyz1006
    @rickyboyz1006 4 роки тому +1

    So what is the auxiliary switch powering??

  • @claytonwilson4301
    @claytonwilson4301 4 роки тому +1

    Why is your A-trac pushed in?

    • @cbatilo
      @cbatilo  4 роки тому +2

      Thank you very much for watching and feedback. My driveway was extremely slippery that day... lol. Seriously... Must have been pressed by accident.

  • @onesearcher100
    @onesearcher100 5 років тому +2

    I am an older guy and hard of hearing. I cannot hear the backup alarm so i wired an LED light into one of those spots so now i see the light when i am getting close to hitting something.

    • @cbatilo
      @cbatilo  5 років тому +1

      That is a great idea! Awesome - ingenuity! Thank you for watching and for the feedback

  • @jerrymellargo3290
    @jerrymellargo3290 4 роки тому +1

    Thx

  • @yeulakho6574
    @yeulakho6574 4 роки тому +1

    Great job.✅

  • @MH-ok2xq
    @MH-ok2xq 5 років тому

    What size fuse did you use on your tap a fuse?

    • @cbatilo
      @cbatilo  5 років тому

      10 amps but you could use less. 7.5 even 5 will work

    • @MH-ok2xq
      @MH-ok2xq 5 років тому

      I'm planning to tap into the unused fuse slot on my FJ. On the Tap, I noticed the two slots. Which slot do I insert the fuse into? The slot where an 'existing' fuse should go into or the 'new' slot? Or does it even matter since it's going into an unused slot in the fuse box? Thanks a lot for the help!

    • @cbatilo
      @cbatilo  5 років тому

      Look at the tap... the one directly next to the wire is the one going to to extra circuit. Not sure if you have seen this vid.. check it out ua-cam.com/video/kDE35YDC_cQ/v-deo.html

    • @MH-ok2xq
      @MH-ok2xq 5 років тому

      @@cbatilo Thanks alot!

  • @ppessoa
    @ppessoa 7 років тому

    Nice work. Where did you purchase the USB voltmeter? Looking for a similar install. Thanks.

    • @cbatilo
      @cbatilo  7 років тому +1

      +Philip Pessoa you can get them from Amazon.com or EBay. Good luck with your project!

  • @DevinRossHerd
    @DevinRossHerd 6 років тому

    Where did you purchase the USB voltmeter?

    • @cbatilo
      @cbatilo  6 років тому

      Devin Ross Herd you can get them at eBay or amazon. This one came from eBay

  • @North3rn_Nomad
    @North3rn_Nomad 7 років тому

    where did you run the ground wire to?

    • @cbatilo
      @cbatilo  7 років тому

      NorCal Woodsman go here: fast forward to : 4:37 ua-cam.com/video/GmVUnr0WRdY/v-deo.html

    • @cbatilo
      @cbatilo  7 років тому

      NorCal Woodsman it's just an existing nut an bolt (holding plastic panel against a metal chassis). I just got another nut for it. In a sense I sandwich the o ring wire connector with 2 nuts (1existing and 1 new).

  • @DBAG716
    @DBAG716 6 років тому

    Where did you get the tablet mount?

    • @cbatilo
      @cbatilo  6 років тому

      I got it at Target. However, they no longer have it. I found an identical one from Bed Bath and Beyond. Amazon has bunch too. Merry Christmas - Happy Holidays!

  • @BaMoOo2007
    @BaMoOo2007 6 років тому

    What the wire gauge (AWG)that been used for wiring?

    • @cbatilo
      @cbatilo  6 років тому

      I say 12 but if it will make you feel better - safety, go with 10.

    • @BaMoOo2007
      @BaMoOo2007 6 років тому

      cbatilo How about 16 AWG ?!

  • @mardarvel1
    @mardarvel1 8 років тому

    the other video is set to private

    • @cbatilo
      @cbatilo  8 років тому

      Strange: here you go: ua-cam.com/video/kDE35YDC_cQ/v-deo.html
      ua-cam.com/video/GmVUnr0WRdY/v-deo.html

    • @mardarvel1
      @mardarvel1 8 років тому

      Thank you!