Ball Joint Replacement: Citroen Relay Fiat Ducato Peugeot Boxer Ram Promaster Van
Вставка
- Опубліковано 27 січ 2021
- here we come to look at a grinding noise on this Citroen relay van.
see it's the ball joint that has failed and we take you through the process of how we replace it - Авто та транспорт
Nice to see you using torque settings.
Nice work 👍
Great video...very informative.
Can you tell me what impact wrench you use please.
Haven’t seen a ball joint that badly worn in years it must have been knocking and banging for a good while good job that you got to it in time a decent sized pot hole and that would have failed
Good video thanks 👍👍
46mm hub nut
On mine it's not more like 50mm
Think the ballpoint is gone in my mazda 5 I've also got a lower booth an seal that's got to get done. Good vid again really enjoyin these tonight with tea and biscuits. #SUPERTECH
Does wheel alignment need doing after replacing ball joint? There must be some adjustment in the positioning of the 3 hole plate to the hub?
Not necessary, no. The position wont change after replacing the ball joint. You do however when replacing bearings/hubs etc. Greg
do you think I would have any chance of getting away with the drive shaft in its place without loosening the nut?
Couldn,t on mine, the hub needed to come out too far, you will need a 42 mm socket( preferably a strong impact type) as the nut is torqued really high.
You could just jack the strut up to remove those bolts, I believe.
Excellent video, just found both worn by mot guy 😂
Oh no!
@@ORileysAutos 😂😂 thought id done well getting the traction control/steering angle sensor sorted
I imagine those are prelubed for life?
really annoying wind noise,
really unhelpful comment,
@@samcabodi Why? Your content is worth criticizing. If it was crap, I would have ignored it. You have a talent worth polishing.