In this motor comparison video, we show you both motors, their design/quality, and what advantages one motor has over the other, and you decide which one is better/more suitable for your next VESC mind-blowing dream machine. 😉👍
Hello Petr, good comparison. Let me clarify We cannot wind our motors by machine due to small quantity. The machine cost is only justifieable if we produce 1000s of motors. However the windings of all motors should be within acceptable limit (a few mm) and should not short with the hub. You can safely ride the motor with confidence if you have any issues you can let us know and we will replace it. We have superfluxes that have completed more than 10,000 miles so we are confident this motor will not let you down. That being said we will talk to the factory to have tighter windings. The wobble bolts is an issue of the past and will never happen again. We will send new bolts to everyone for free who has loose bolts on their HT motors.
You should have 2 power l1 and l2 ( hot and negative ) and 3 hall sensor wires. The hall sensors are self explanatory. The hot and neutral are the other 2. Do you have a specific question ?
Probably I'm going to use a 5-minute epoxy or silicone. Please note: do not use epoxy that hardens like a rock, because it will be very difficult to remove it, if it's needed.
In this motor comparison video, we show you both motors, their design/quality, and what advantages one motor has over the other, and you decide which one is better/more suitable for your next VESC mind-blowing dream machine. 😉👍
Hello Petr, good comparison. Let me clarify We cannot wind our motors by machine due to small quantity. The machine cost is only justifieable if we produce 1000s of motors.
However the windings of all motors should be within acceptable limit (a few mm) and should not short with the hub. You can safely ride the motor with confidence if you have any issues you can let us know and we will replace it. We have superfluxes that have completed more than 10,000 miles so we are confident this motor will not let you down. That being said we will talk to the factory to have tighter windings. The wobble bolts is an issue of the past and will never happen again. We will send new bolts to everyone for free who has loose bolts on their HT motors.
Thank you
Thanks for the useful information.
You are welcome 😉
👍👍👍
Thank you 😉👍
Nice analysis, thanks!
You are welcome 👍
I'm looking for more info on swapping my hypercore connectors to a superflux connector.
You should have 2 power l1 and l2 ( hot and negative ) and 3 hall sensor wires. The hall sensors are self explanatory. The hot and neutral are the other 2. Do you have a specific question ?
thank you.
YOU are welcome
What type of epoxy would you recommend using to minimize the movement / flex of the board?
Probably I'm going to use a 5-minute epoxy or silicone. Please note: do not use epoxy that hardens like a rock, because it will be very difficult to remove it, if it's needed.
When will the superflux come back in stock
It looks like the item is currently in stock.