ok so i just got mine and have been fighting the bed level since i started using it. tonight, it was really pissing me off and have had several failed prints. anyway i started googling for solutions and this vid popped up and while it wasnt very informative, your random assed comment was however. I did just what you suggested (and honestly no one and i mean FUCKING NO ONE) had ever mentioned this little tidbit of information. so i did it. i did it fully expecting it to fucking fail and it fucking worked! so yeah thanks for the tip, that did the trick and got my bed levelled. athough i havent figured out what to do about the middle bit when manually tramming the bed (is there an adjustment or is that the last one you do to check if its trammed correctly? again no information) thank you.
I'm sure you're supposed to turn the screws until the light goes off That's how I've been doing it with mine and it's working fine
ok so i just got mine and have been fighting the bed level since i started using it. tonight, it was really pissing me off and have had several failed prints. anyway i started googling for solutions and this vid popped up and while it wasnt very informative, your random assed comment was however. I did just what you suggested (and honestly no one and i mean FUCKING NO ONE) had ever mentioned this little tidbit of information. so i did it. i did it fully expecting it to fucking fail and it fucking worked! so yeah thanks for the tip, that did the trick and got my bed levelled. athough i havent figured out what to do about the middle bit when manually tramming the bed (is there an adjustment or is that the last one you do to check if its trammed correctly? again no information) thank you.