Semi Truck King Pin Replacement
Вставка
- Опубліковано 2 вер 2021
- Thanks For Watching!!! Please Like And Subscribe.
Please check out semiworkin.com
In this video I'm replacing king pins on the front of a semi truck.
Tools Used:
3/4" Air Impact Wrench: amzn.to/3nW2ZcN
1/2" Air Impact Wrench: amzn.to/2M1bV2l
3/4" Axle Nut Socket Set: amzn.to/35eFdRW
Oil Suction Gun: amzn.to/3nsuMAw
As an Amazon Associate I earn from qualifying purchases.
the same type of king pin I have replaced about two months ago. It took me 3 days to change all 4 of them on an Astra HD 8, 8x4 truck. But they wouldn't come out nowhere near that easy. Taking them out i had to use a 50 tone press, a 15 kg hammer and on one of them also the gas torch to crack the rust.
Great work guys no crazy mess very clean
you make it looks so easy!!!
Great video to stumble on. I really enjoyed it. With the cotter pins, if you clamp on them with the diagonal cutters and use a pivot point like a wrench or a bolt to roll the pliers on. The nut usually works fine. Just dont smoke the exposed threads. It pulls them out like nothing almost every time. Those tie rod covers are awesome to beat on just ordered some. Thanks again!
EXCELLENT WORK.... THANK YOU... HELP ME A LOT.... GREAT JOB...
Great job
Thanks a ton for this video. Truly
Wish it was always this smooth
Nice video, thanks
👍👍Great job
Amazing👍👍👍
Buen video, estoy haciendo el mecanismo del eje y suspención versión juguete.
Good job thanks
Nice work
Alignment is needed after?I have a 680 and it is in Kenworth right now and they want to replace both front Kingpins. Thx for the video
Thats only magik, that the kingpin was beating so easy.
❤️❤️❤️😃
If that where me doin this job I'd be there for 2 days fightin with that damn cotter pin.
Love your content but that 3/4 needs replacing and it much slower than a 1in for taking the lugs loose
Good video but didn't show replacement of the kingpin bushings