Nice work. Not time yet for me to do ours but I know it will be some day. Read a guys post on iRV2 today who’s about to replace his. Figured I’d check videos. Great job. Thanks
If you cut the all-thread nut at the correct length, you will be able to thread it on there. Too long it will not fit and too short you cannot get the wrench on for the last tightening. I got lucky on my cuts. I was just winging and not referring back to the iRV post like I should have after reading it few weeks before I went for it.
Thanks for your post! I appreciate your contribution!
Nice work. Not time yet for me to do ours but I know it will be some day. Read a guys post on iRV2 today who’s about to replace his. Figured I’d check videos. Great job. Thanks
After inserting new bags was it hard to get the new nut started and tightened? Did u have to cut the stud down a bit or was it perfect length?
If you cut the all-thread nut at the correct length, you will be able to thread it on there. Too long it will not fit and too short you cannot get the wrench on for the last tightening. I got lucky on my cuts. I was just winging and not referring back to the iRV post like I should have after reading it few weeks before I went for it.
AB1DK20D-9584 Air Spring Rolling Lobe - Less than 1/2 $$$
Nice job. Save you a few dollar's.
What is the kack
Sorry, not sure I follow about which part of the process is the knack.