Hi thanks for your video. I have different brands subs/tops which i use and experience the phase issue/cancelation. Which driverack or procesor has the inverted phase option to solve the cancelation peoblem? Thanks! Brian
@@BrianAvans Hello, please if you are sure is Phase invert the speakers need, u can check out Dbx-PA2-260 and 360. Or u can try Ashley DSP these are the low budget . If you want expensive on please check Lake
Hello! You can do that by using two computers and two audio interface. But if you have only one am sure what am going to say will be understandable for you. Smaart have two out for sending signal out. I used only 1 output from smaart, and in Reaper I activated the input to listen to the input of the reference signal. After I send only 1 mono signal from reaper to my audio interface output. Remember I used only 1 output from smaart. So the output of reapers comes in as my measurements microphone that's is input one. I no is confusing, but that's how I did it.
Hi thanks for your video.
I have different brands subs/tops which i use and experience the phase issue/cancelation.
Which driverack or procesor has the inverted phase option to solve the cancelation peoblem?
Thanks!
Brian
@@BrianAvans Hello, please if you are sure is Phase invert the speakers need, u can check out Dbx-PA2-260 and 360. Or u can try Ashley DSP these are the low budget . If you want expensive on please check Lake
@samuelkennethacquah1068 Thank you for your reply!👍🏽
gr8 video ✅
Thanks sir
Hello please How do you route reaper signal on Smaart or Smaart to Reaper?
Hello! You can do that by using two computers and two audio interface. But if you have only one am sure what am going to say will be understandable for you. Smaart have two out for sending signal out. I used only 1 output from smaart, and in Reaper I activated the input to listen to the input of the reference signal. After I send only 1 mono signal from reaper to my audio interface output. Remember I used only 1 output from smaart. So the output of reapers comes in as my measurements microphone that's is input one. I no is confusing, but that's how I did it.
Alternatively, on MacOS you can use Blackhole from Existential Audio.
Which software used for this can you share plz ??
@@krishnajadhav7836 I used smaart for this. Visit www.rationalacoustics.com
Hey can you make a video doing connection and set software
Please about which connection
@@samuelkennethacquah1068 like how to connect your mixer to your audio interface and then to your PA system how to set up your software
Okay sir I will look into that
@@samuelkennethacquah1068 really appreciated waiting for your video ❤️
Yes please
that happens when you use the same filter !!
yes and even if you use different filters the phase slopes will mismatch. thanks for the comment