Not sure you will get this. If you do here is my problem. 467 jd baler net wrap issue. On occasion a bale will be wrapped numerous times beyond what it is set at. Finally stops wrapping with no error codes sent. Any ideas what causes this?
A lot of time this happens if the rubber roll is not completely smooth. If there is a cut or nick, or maybe ever some built up material on it sometimes the net will catch and start to wrap around it.
On my Bale Trak Plus, you push the "bale diameter button" (2nd button from the left on the bottom). Then, use the +/- buttons on the bottom right to adjust larger or smaller. 🙂
![Lp. Сердце Вселенной #60 РОЖДЕНИЕ ЛОЛОЛОШКИ [Финал] • Майнкрафт](http://i.ytimg.com/vi/YoR0pAV9FVQ/mqdefault.jpg)
Good video bud thanks
Great information. Where can I get one of those Bale Trak Pro Code Cards? Thanks.
I use a temp gun to check 4 bad bearings
I gota question 4 ya i got a jhon deer 5083e and it dash is on KM instead of MPH how do i get it back to MPH??
Great video! What size is them chains on a 5x6?
Not sure you will get this. If you do here is my problem. 467 jd baler net wrap issue. On occasion a bale will be wrapped numerous times beyond what it is set at. Finally stops wrapping with no error codes sent. Any ideas what causes this?
How about some information on Older John Deere balers 330,430,435
Wat u Wana know about them
My 466 will not feed the net its not rap up any where was working amonth ago any ideas
I got a 456 silage special.
Unfortunately sometimes the net is wrapping around one of these rubber rollers in the back of the baler. WHY ?
A lot of time this happens if the rubber roll is not completely smooth. If there is a cut or nick, or maybe ever some built up material on it sometimes the net will catch and start to wrap around it.
Our 569 baler is set to 67 inch bale but makes oversized massive bales and I get oversize alarm everytime what can I do
On my Bale Trak Plus, you push the "bale diameter button" (2nd button from the left on the bottom). Then, use the +/- buttons on the bottom right to adjust larger or smaller. 🙂
Our 569 baler is set to 67 inch bale but makes oversized massive bales and I get oversize alarm everytime what can I do
Adust the bale size sensor