Spyderco ENDURA 4 K390 (full sharpening)

In this video, I demonstrate how I sharpened the Spyderco Endura 4 in K390. The edge had an uneven bevel, so I began by reprofiling it using an ultra-sharp diamond plate 300 grit. Then, I moved on to the Greater Dog series by Venev, starting with F150, F240 and moving to F400, followed by Venev Orion at F400, F800, and finished with F1200. After that stropping with 1 micron gunny juice, loaded it on the Jende nanoclotch . Then, I used 0.5 micron stroppystuff on Balsa and 0.25 Micron stuffystuff on Balsa. If you enjoyed the video, please share it and give it a thumbs up. Thank you!
#zulukilo_edgewerx
#kuching#sibu#bintulu#miri #besharpstaysharp
#sharpening #sharpeningstone #knife #sharpeningclaws #sharpeningstones #sharpeningservice #sharpenings #knives #sharpeningtools #sharpeningskills #sharpeningmyskills #sharpeningsteel #sharpeningknife #sharp #knifesharpening #sharpeningknives #sharpeningblades #edc #knifecommunity

[@itv7476]

Off the various diamond plate, assume at the same grit which would you recommend? Atoma, DMT diasharp, Ultrasharp, sharpal, Spyderco CBN?

[@zulukiloedgewerx]

Thank you for the comment and feedback. For my preferences at the same grit (for diamonds in descending order) I go with Atoma, Ultrasharp and Sharpal & DMT
Spyderco CBN stands on its own just because the finish it leaves is finer than the diamond. Diamond cut deeper than CBN.. in terms of speed it is the same for both.