in this video i show you where i have been these past years and where the fergie is at now. sorry the audio cut out in the last clip. like comment subscribe.
It’s dry I promise 😉😂 and I coat every bright surface in oil, it was just because today it was raining pretty hard and with the block being in the door way it get abit of drizzle on it, plus when I shut the container up I wrap it in 2 tarps
Wasn’t too bad. I had to buy a new head all together as my original one was cracked. But for the skimming and valve grinding I believe it was about £100 then for the crank being machined to the next size bearings with he bearings supplied it was £90
@@samuelbygrave that's not bad at all. I've never done any of it but that sounds cheaper than I expected. Looking forward to seeing yours progress. Would love to see and hear more of the process you go through with it. Good luck
@@vehicle_entrance thank you! You definitely will, My video making ability’s have slipped abit with not making many is a while but I’m sure it will get better and more detailed.
Glad to see you back!
Glad to see you back I've got some heavy haulage videos of traction engines working hard at beamish museum
It all looks quite wet in that container. The head looks very damp, not sure if its the best conditions to have an engine block wide open…
It’s dry I promise 😉😂 and I coat every bright surface in oil, it was just because today it was raining pretty hard and with the block being in the door way it get abit of drizzle on it, plus when I shut the container up I wrap it in 2 tarps
I'want start may tef20 1955 but i'not find the pièces.
Hello, I am from Mexico, and I need help to be able to put the injection pump of my TEF20 on time.
Can you help me with a diagram or manual or video?
Was it expensive to get the head reconditioned?
Wasn’t too bad. I had to buy a new head all together as my original one was cracked. But for the skimming and valve grinding I believe it was about £100 then for the crank being machined to the next size bearings with he bearings supplied it was £90
@@samuelbygrave that's not bad at all. I've never done any of it but that sounds cheaper than I expected. Looking forward to seeing yours progress. Would love to see and hear more of the process you go through with it. Good luck
@@vehicle_entrance thank you! You definitely will, My video making ability’s have slipped abit with not making many is a while but I’m sure it will get better and more detailed.