Thanks for watching. Do you mean show some pictures of the end result in my video? Or perhaps I misunderstood and you mean uploaf the design in LightBurn?
Another nice project! I'm doing 8 layered mandala's at the moment, I see a lot of similarities in our work flow. Looking forward already to see your next project :)
Thanks for watching my videos and great to hear you enjoy my content. I've too done some projects with 8 or more layers and these are a lot of fun to do. Did not do any mandala's yet, but have saved a few in my favourites. Really want to do one soon as I think the're pretty cool.
Yours videos are amazing, good job and well explained! I was wondering , which kind of wood do you use for your laser work ? Do you go to your local DIY and buy standard plywood or do you have a supplier who stocks special laser plywood. I live in France near the Belgium border so not so far from you and I am always looking for a good wood supplier even outside France. Thank you for your work.
Thanks for watching and your nice comment! I just buy them at our local DIY store as I do not need too much. Dedicated woodstore might be better priced though. Or buy full sheets if you can transport them. That's also less expensive than buying sheets 122x61cm. I use 3mm plywood like here below, have great results with these (nice and very clean cut) www.karwei.nl/assortiment/timmerplaat-multiplex-122x61-cm-dikte-3-mm/p/B818520
très bon travail bravo et merci
It would have been nice to see you upload the photos but this is nice!
Thanks for watching. Do you mean show some pictures of the end result in my video? Or perhaps I misunderstood and you mean uploaf the design in LightBurn?
Another nice project! I'm doing 8 layered mandala's at the moment, I see a lot of similarities in our work flow. Looking forward already to see your next project :)
Thanks for watching my videos and great to hear you enjoy my content. I've too done some projects with 8 or more layers and these are a lot of fun to do. Did not do any mandala's yet, but have saved a few in my favourites. Really want to do one soon as I think the're pretty cool.
Great work!
Thanks!
Yours videos are amazing, good job and well explained! I was wondering , which kind of wood do you use for your laser work ? Do you go to your local DIY and buy standard plywood or do you have a supplier who stocks special laser plywood. I live in France near the Belgium border so not so far from you and I am always looking for a good wood supplier even outside France.
Thank you for your work.
Thanks for watching and your nice comment! I just buy them at our local DIY store as I do not need too much. Dedicated woodstore might be better priced though. Or buy full sheets if you can transport them. That's also less expensive than buying sheets 122x61cm.
I use 3mm plywood like here below, have great results with these (nice and very clean cut)
www.karwei.nl/assortiment/timmerplaat-multiplex-122x61-cm-dikte-3-mm/p/B818520
@frchguy you're welcome and I will 👍🏻