I have their strut mounts. They look great. Didn't know they had access covers. Now, the choice is Edge Red or Elkhart Lake Blue. Curious about the latch plate.
I really appreciate your video. I have been looking at these pieces from C8RallyDriver. When you did the install, of the supports, how did you support the back hatch when you had the old support off? Was there someone off camera holding it?
@@marcg1964 Thank you. I have a padded prop rod I use quite a bit to hold things while I film. It’s come in handy many times. You won’t be disappointed if you go with any of the C8RallyDriver products…. They are very high quality! Thanks for your question!
@@dbmracing2019 Thank you so much for the reply. I would love to see a video of the latch plate install too. I'll be at Carlisle next Friday...only a two hour drive for me.
@@morrisbaker4351 Injected Engineering in Kennesaw GA. Have video of that on channel for the Paragon exhaust install and dyno tune. I would do it myself now but that was very early on after I got the car
Can’t wait to see EVERYONE!
Can’t wait to see it next week!
@@kevinhoran2091 I can’t wait to see everyone again and hopefully meet lots of new folks
Those access covers are pretty nice looking.
Thanks for the video.
@@larrynewberry3500 Thanks Larry!
Those look super nice man!
@@Brandonsgarages thanks man!
Man those look amazing
@@v8behind They really do! I am so happy with them! Thanks Michael!
Carlisle is going to be such a good time
Looks sweet see you guys there
I literally have the same set of stuff to put on before Carlisle lol
@@HorsePowerObsessed Oh man! If you have all this and your new torch red intake!! Going to be one of the HOTTEST Z06’s out there
lol "grubby fingerprints"
@@HorsePowerObsessed hahahahah
I have their strut mounts. They look great. Didn't know they had access covers. Now, the choice is Edge Red or Elkhart Lake Blue. Curious about the latch plate.
@@johnperkins6432 those latch plates are SOLID man. I installed it on the next day but haven’t edited it yet. It’s heavier than stock though
Great looking mods. Is the access cover a coupe only part?
@@Texas_Clay Website says coupe. I’ll ask and get back to you Clay. Thanks 🙏
I really appreciate your video. I have been looking at these pieces from C8RallyDriver. When you did the install, of the supports, how did you support the back hatch when you had the old support off? Was there someone off camera holding it?
@@marcg1964 Thank you. I have a padded prop rod I use quite a bit to hold things while I film. It’s come in handy many times. You won’t be disappointed if you go with any of the C8RallyDriver products…. They are very high quality! Thanks for your question!
@@dbmracing2019 Thank you so much for the reply. I would love to see a video of the latch plate install too. I'll be at Carlisle next Friday...only a two hour drive for me.
@@marcg1964 Please come by and see us at Carlisle! I hope to get the plate install video out before Carlisle. Thanks!
Dave are you driving the vette from GA to PA?
@@Texas_Clay Towing
Who installed your exhaust
@@morrisbaker4351 Injected Engineering in Kennesaw GA. Have video of that on channel for the Paragon exhaust install and dyno tune. I would do it myself now but that was very early on after I got the car