AUMA Actuators - EWG Feedback

In this video see how to set the EWG Feedback device.
This video is for general guidance, always refer to the operating manual for product specific instruction and safety precautions.
AUMA Actuators, Inc. has been manufacturing valve actuators for more than 50 years and is a major supplier of electric actuators and manual operators to industry.
AUMA electric actuators are capable of operating all types of quarterturn valves (butterfly, ball and plug) and multiturn valves (gate, globe, sluice gate and pinch). AUMA actuators are also widely used to operate dampers (louver, guillotine and diverter). Actuators can be furnished for both open/close and modulating service. Integral motor controls and control accessories are available to interface with a wide variety of plant control systems.
AUMA Actuators, Inc. is headquartered near Pittsburgh, PA. AUMA's Quality System is in compliance with the requirements of ISO 9001. A complete network of sales and service support is available throughout North America. Regional offices are located in the Northeast, Southeast, Midwest, Gulf Coast and West Coast. Representatives and distributors are located throughout the United States, Canada and Mexico.

[@bw26brw86]

Good day how do I setup the 4 - 20mA feedback to scada

[@kysuci4105]

thanks.

[@faisalmalik7408]

exilent

[@shamsulhoda1897]

How to inject the 4-20mA in Auma Actuator

[@seagle85]

I need help understanding how to wire my valve

[@dyto1715]

My auma was good. I tried to do this way .but now stopped at 5.7 mA when i send zero from scada.but open and close local are working fine.i use 3_4 wire but .wiring only at 23 .24 could you tell me .how can i solve this

[@AUMAActuators-USA]

Hi DyTo, can you please provide me your location so I may connect you with a local service representative?

[@saithishsaje9653]

I need solutions for open and close feedback

[@perdesh1990]

If you find tell me also

[@asirasperislamicruleswitho3022]

AUMAN MANUFACTURER ENGINEER ELECTRIC CIRCUIT DESIGNER IS NOT GOOD , I Received The valves we Done Heavy Mistake during Calibration due to bad engineering , I Auma NEED i can Highlight these issue with your Engineer.

[@AUMAActuators-USA]

Hi Asir, can you please provide me your location so I may connect you with a local service representative?