Comment is old but I'll reply. The buttons are magnetically operated and not serviceable without destroying the cover. Where I work as the instrument tech I take the cover off remove circuit board and use a small magnet to operate the buttons. It's not a great fix but we have about 18 of these and all the cover magnets are bad. The units we have are maybe 4 years old. Was told by Auma they had a bad batch and would send us all new ones. Still have not heard back...
The MWG is the control unit inside our actuator. It consists of magnetic encoders that measure torque output and determines and reports actuator position. The MWG will only work with the AC01.2 motor controls and It is located in the actuator surrounded by a protective plastic casing
Good job! Very easy.
Thanks!
Sir how to solve erratic reading of the valve opening percentage in Remote operation.
How can a valve with a half-inch opening set to 20 milliamps? If another valve also has an inch opening, set to 20 milliamps?
I jave a problem setting the limits, I save the limits, then i made local test and it takes a very small route that I don't set, what is rhe problem?
Hello. There is a problem with the push buttons on this device. Where can we get information about their repair?
Comment is old but I'll reply. The buttons are magnetically operated and not serviceable without destroying the cover. Where I work as the instrument tech I take the cover off remove circuit board and use a small magnet to operate the buttons. It's not a great fix but we have about 18 of these and all the cover magnets are bad. The units we have are maybe 4 years old. Was told by Auma they had a bad batch and would send us all new ones. Still have not heard back...
Auma actuator MWG fail sensar 0007 what's problem sir tel me
Sir auma actuator MWG work shop manual need sir
Why showing position undefined plz tell me sir
Sir, the screen is red, what is the reason for this? And you don't receive anything?
Sir what exactly is MWG
The MWG is the control unit inside our actuator. It consists of magnetic encoders that measure torque output and determines and reports actuator position. The MWG will only work with the AC01.2 motor controls and It is located in the actuator surrounded by a protective plastic casing
@@AUMAActuators-USA Sir when dose user calibrate via MWG and GTLS Mechanical limit switches? or can use either one
Sir AUMA actuator MWG fail sensor what's the problem