HAM RADIO: How to connect a N-Type Coax Connector.

[@berry888]

thank you for your tutelage. now i may challenge the spliced coax

[@provosttq2051]

Using the pliers to stabilize the coax during soldering is a nice touch. I'll have to remember that one.

[@g4lmn-ron401]

A couple of points.
Don't ever do this anywhere near your radio equipment. The short lengths of cut off braid can find their way into equipment via ventilation holes and cause shorts of the circuit boards. It REALLY spoils your day.
Instead of a soldering iron, if you have a heat gun with a small nozzle that can work better to solder the pin.
Nicely done Mike!

[@mike-M0MSN]

some good points here.

[@markramsay6399]

Thanks Mike, great video as always. Mark, 2E0MSR

[@mike-M0MSN]

Thanks Mark

[@davekettle6220]

mike thank you for doing the quiz with cal and john i really enjoyed it could stop laughing merry chrismas to you

[@mike-M0MSN]

Thanks Dave. HNY

[@PaulMoorhousehankooks]

good job

[@mike-M0MSN]

Thanks

[@sveinfarstad3897]

Fantastic Mike, Don't listening to Cal, Hehehehe 🤣🤘🤘🤘

[@mike-M0MSN]

Too late

[@ChrisBartlett-y6q]

Pleased to see you have the Red go faster grommet. Worth a few Banans that is.

[@mike-M0MSN]

Yes, 😅😂

[@paulwilliamstrainingservic9691]

Very 👍

[@DXCommanderHQ]

Can you show us how to fabricate LD-F450 next!!?? PS - I can't wait to read the comments telling you how you got this comletely wrong! LOL

[@iceman6555]

😂😂😂😂😂😂😂😂😂

[@sveinfarstad3897]

Solder iron under not ontopp 🙂 and a few more, hey don't press him, he's your friend

[@ZeroHarry]

Mike got it wrong.... He installed the connector on the wrong end of the coax!

[@mike-M0MSN]

😂😂

[@Marcel-PG0M]

No flat washer between the bottom nut and the grommet Mike ?

[@M7XCB]

I brought same plug can't remember where from came in the sealed packet it was no washer I didn't like it. I get all my different plugs from m0mat very good quality with washer.

[@mike-M0MSN]

Yep no slip washer supplied, very expensive n-types too.

[@SHOWERHOSPITAL]

Put an elastic band around the pliers handle..you then have a vice...

[@mike-M0MSN]

Great idea

[@rondillon4136]

Cracker video as usual Mike…..But… please loose that awful music…. Your videos don’t need music.lol

[@mike-M0MSN]

I will try to remember

[@martindavies6640]

Great video Mike as always very informative best wishes and a merry Christmas to you and your family. De mw0cnd Martin.

[@mike-M0MSN]

Same to you!