Boss Airbag Assembly

Поділитися
Вставка
  • Опубліковано 2 гру 2024

КОМЕНТАРІ • 13

  • @twogates233
    @twogates233 10 років тому +1

    i fitted boss air bags couple mnts ago and fitted as per instructions ,having been in the motor game for 45 odd yrs was simple enough ,i was concerned about the uneven surface of the rubber moulding of the bags where it seals to the top &bottem plate but was assured no sealer was required so fitted it hoping they wouldn't leak" WELL THEY DO" !!which is a pain so i'll have strip the bloody lot again to see whats going on .

    • @ethanbatt5583
      @ethanbatt5583 6 років тому

      twogates233 put mine in today and boy am i fucking dissapointed mine leak too

  • @LoftyProduction
    @LoftyProduction 8 років тому +1

    I am a bit skeptical about aftermarket wheels as I had a bad experience last time. Long story short, my first ever car was a little micra 1.0 and i got all the kit to fit a new steering wheel. Anyway, first of all it needed a special security torx bit which only garages can buy, then when I finally found a garage that had one, they rang me back and said, look if we fit this it means you would lose your indicator stalks and airbag making the vehicle illegal and wouldn't pass it's MOT. I've just purchased a fiat punto grande active 360 1.2 hatchback. I'd like to install a new wheel but I am not going through all the hassle that I went through previously. Could anyone 100% say to me that a new wheel can be fit without any legal/mot/insurance issues. Thanks lads.

  • @karimsamandar1557
    @karimsamandar1557 7 років тому +1

    Hi sir i need the three air baloon for my air lift jack

  • @abisayb17
    @abisayb17 2 роки тому

    Como comprar este producto en panama?

  • @gregorylemesurier4005
    @gregorylemesurier4005 2 роки тому

    How can that not leak air ?

  • @rodneywatson8994
    @rodneywatson8994 10 років тому

    So why don't you apply a sealer between the bag and the plates?

  • @knightmpw
    @knightmpw 6 років тому +1

    Hi.... Im keen to have a pair of these in my 79 v8 cruiser. But before that please answer these two questions.
    1. I have a 4inch lift. So do i have to buy any additinal parts with the three bag vehicle specific kit?
    2. When im not on camping, my rear will weigh not more than 100kgs (excluding the weight of the tray.) so what will be your recommended air pressure for this case?

    • @BossAirSuspension
      @BossAirSuspension  6 років тому

      Hi there, all you will need is the triple airbag kit for the 4" lift. When you have no weight in the vehicle you could run it at around 5psi

  • @rentacampervanholidaysltd8572
    @rentacampervanholidaysltd8572 10 років тому

    It is possible to fit into ALKO spring type axial?

  • @karimsamandar1557
    @karimsamandar1557 7 років тому

    How can I get this. I will send the old picture.

    • @BossAirSuspension
      @BossAirSuspension  7 років тому

      Hi Karim, where abouts are you located? Can you shoot through your email address, we will get someone to make contact.