Camaro LT1 Speed Engineering Long Tube Headers Install (2 inch)
Вставка
- Опубліковано 15 вер 2024
- Today I install 2 inch speed engineering long tube headers and a e 85 flex fuel sensor and I get tuned by Pat G 
I plan on posting more videos like this and will have more clog type videos with installs and keeping you guys updated on the car!
#camaro #lt1 #10speed #headers #e85tuned
Wow u did all the work urself 👏 sounds awesome
Nice install make sure you secure that main harness away from the header on passenger side tends to shift over time and sit really close to that header
Glad its still somewhat quiet in stealth mode..
What’s your wheel and tire setup
The tune for the headers is just to get rid of the check engine light right? How much do those usually cost
how long did this take you and i think ima change my headers too eventually 😄😄
literally took 2 full days
Have you brought it to the track,own a 23 1ss myself m6.
What was the whp, and mods you have on? Is there a reason y u have stock manifold and TB I plan on getting the ported lt2 and 95mm TB on my 2021 lt1
My tuner estimates 460ish on pump gas an 480ish on e85 and i plan on getting a manifold and tb next, as of rn the cars is just the long tubes rotofab and e85
@@BradleyLT1 I had my 22 SS 1LE tuned when I had rotofab & 2in headers & LT2 intake.. It made 461whp.. and mine is manual.. bone stock it was 416whp.. Could have got another 10 or so on some "E" but I aint messin with that.. Got a BTR 225 cam but haven't got it put in yet.. Can't decide if I want to do the heads or leave em alone.. I really don't care to be faster, just want that chop..
did you have any fitment issues with the 2in?
passenger side was a bit difficult
No car has 4 catts, only 1 or 2. Most domestic V6-V8's have 2. Those two cans in rear are resonators.
the car has 4 cats 2 pre and 2 post cats. please do your research before commenting.
So you still have the big Fuel tank looking stock muffler on???
Nah he said he had the factory NPP exhaust. NPP mufflers actually look like mufflers
@@willlloyd7762Incorrect. The suitcase/fuel tank looking thing is NPP.
Hey bro I have a 2024 lt1 and I wanted to go with the speed engineering headers as well . What’s the difference between the 1-7/8” and the 2”?
I had just seen some videos of the 2 inch making a few more hp so i just went with those but the 1 7/8 are great too if there is a difference it’s very slight, but i can definitely tell you the 1 7/8ths would be easier to get in
@@BradleyLT1 thanks bro
The 2" will lose power until heads and cam are done and a cam and regular lifters is needed to remove the weak V4 afm/ dod.. 17/8 is best. Get them heat coated too.
what engine u got 😅
6.2 lt1
☹️ P r o m o s m