Replacing a broken (inside) door latch cable on a Tiburon

Поділитися
Вставка
  • Опубліковано 1 січ 2025

КОМЕНТАРІ • 31

  • @Thejparmstrong
    @Thejparmstrong Рік тому +1

    Thanks. It was very useful to watch the detailed breakdown of all the clamp spots. I was able to find my issue right away. Next video, don’t use music. It doesn’t mix at the same level as your voice, and blasts out the speakers.
    Otherwise perfect video.

  • @Mr.Bisquik
    @Mr.Bisquik Місяць тому

    Thanks! I currently have the same issue on the driver side door on my 04 GT and need to replace my cable too. Getting tired of opening the door from the outside latch. 😂

  • @warrenhodge8487
    @warrenhodge8487 3 роки тому +4

    Thank you for the clip it was helpful as i have thie exact issue on my Tiburon, my only constructive criticism is the music. Too loud buddy.

  • @seanbn83
    @seanbn83 4 місяці тому

    On point bro 🎉

  • @davidcollins7050
    @davidcollins7050 3 роки тому +2

    Excellent instructional video! I’m very impressed on the details and the explanation of everything. Great job 👏

  • @davincimemes3631
    @davincimemes3631 2 роки тому +1

    Thanks for sharing bro!

  • @aaronefrainchavez5638
    @aaronefrainchavez5638 2 роки тому +1

    On the minute 1:00
    How did you take out the little covers on the screw?
    ‘Cause I don’t know how do that😢😅

    • @Jay_Driscoll
      @Jay_Driscoll  2 роки тому +1

      That can be difficult. A small standard screw driver can be used to pry the covers off. Try wedging the pointy end in between the cover and the door card (don’t worry about scratching it because it’s not very visible most of the time).
      Best of luck!

  • @alexthompson9876
    @alexthompson9876 Рік тому

    Well made video ! Thank you!

  • @djamesdd1987
    @djamesdd1987 Рік тому

    thank you, need this exact thing!

  • @daltonz-backup6318
    @daltonz-backup6318 3 роки тому

    Very helpful for me to get it off to wrap

  • @FayaStyle971
    @FayaStyle971 3 роки тому +3

    Hi, Does this cable go on 2 sides? I have to change the cable on the passenger side on the right.

    • @Jay_Driscoll
      @Jay_Driscoll  3 роки тому +1

      I suspect that the cable is the same since the door locks and handle function the same on both sides and when I ordered the part I didn’t specify left or right

    • @jimi4985
      @jimi4985 Рік тому

      Hey, did it fit on the passenger side? If not, what did? Facing the same issue now.

  • @teinte411
    @teinte411 Рік тому +1

    Hey man, thanks for the video. Very helpful. I just need to replace the door handle latch that broke, it's coming Thursday. My cables are fine. I took off my cover and it looks like I could possibly change it out without taking the door off, but it does look tight. I was just wondering if you know if the latch and lock assembly could be done by just removing the cover and sneaking it through? Thanks.

    • @Jay_Driscoll
      @Jay_Driscoll  Рік тому +1

      Good day. I think you should be able to unscrew the additional screw (hidden under the white tape) and slide the handle assembly to release it. What I am not sure about is how difficult it would be to reconnect the latch and lock cables to the assembly in such a small space. Best of luck and please let us know if this was possible.

    • @teinte411
      @teinte411 Рік тому

      @@Jay_Driscoll Will do! Thanks bud, I'll give it a try.

    • @teinte411
      @teinte411 Рік тому

      ​@@Jay_DriscollI was able to replace it without removing the door panel. It was a bit difficult however, but doable. You have to snap in the plastic into the door first, then connect the cables because there is no slack on the cables if you don't remove the door panel.

  • @lissalea8014
    @lissalea8014 Рік тому

    I’m going to attempt this. I already have that exact part.
    What tools will I need?

    • @lissalea8014
      @lissalea8014 Рік тому

      Is it just a flathead and a phillips screwdriver?

  • @josephbillanes3017
    @josephbillanes3017 2 роки тому

    How did you remove the adhesive from the door?

    • @Jay_Driscoll
      @Jay_Driscoll  2 роки тому +1

      I used mild heat well pulling the plastic door film away from the door. I may have ripped the plastic slightly but I am not concerned with that and just restruck the same film on the adhesive. Best of luck.

  • @FayaStyle971
    @FayaStyle971 3 роки тому

    Merci beaucoup 😩🙏

  • @ukaszLaskowski1
    @ukaszLaskowski1 7 місяців тому

    very useful video from like 2004 when you whisper to microphone then YOU UNEXPECTEDLY DEAFEN THE PEOPLE WHO DARED TO INCREASE VOLUME TO HEAR YOU. I wish I read comments beforerahnd

  • @sergio.sabater
    @sergio.sabater 3 роки тому +1

    Thank you so much for this video! I have strange behaviour on my tib, first I thought it was due door lock actuators. I changed both but problem still happens. Is able to open both doors without problems but for some reason left door don't close from right side, only right. I think it could be because of this cables.

    • @Jay_Driscoll
      @Jay_Driscoll  3 роки тому

      Best of luck. I am curious to know how you fix the problem be sure to update me.

  • @nonename3089
    @nonename3089 7 місяців тому

    The only thing i needed is the only thing you didnt show, HOW TO TAKE OFF THE BROKEN CABLE INSIDE THE DOOR

  • @WelhamGaming
    @WelhamGaming 2 роки тому +2

    The disparity between the volume of your voice and the volume of your music is deafening. You should look into learning how to master your audio a bit better! Thank you for the descriptive explanations though, helped me fix my door!