Holley Performance Hi-Ram Intake and Fuel Rails | Project Last Chance C10

Josh installs a Holley Performance high ram intake, fuel rails and 92mm throttle body on his '67 C10 aka Project Last Chance
Hi-Ram Intake:
www.holley.com/products/engin...
42 lbs Fuel Injectors:
www.holley.com/products/fuel_...
92mm Throttle Body:
www.holley.com/products/fuel_...
Contact the builder:
FB - Josh McPherson
IG - @bazertheblazer
Magazine Subscriptions!! engagedmediamags.com/automotive​
Street Trucks:
IG - @streettrucks
FB - streettrucks
Magazine - engagedmediamags.com/automotive
C10 Builder’s Guide:
IG - @c10buildersguide
Magazine - engagedmediamags.com/automotive
OBS Builders Guide:
IG - @obsbuildersguide
FB - groups/obsbuildersguide
F100 Builders Guide:
IG - @f100buildersguideofficial
Magazine - engagedmediamags.com/automotive

[@mikeypooh1]

This guy is actually funny. I enjoy watching this videos. Keep them coming.

[@spesh1300]

My kit came with spacers for rhe fuel rails . Do those go between the manifold and the rail ? The spacers put the rail croooked either way if they are on before or after

[@kevincrochet3427]

To my knowledge, Holley doesn’t send the steel braided crossover with their hi-ram, only the fuel rails. Can you provide a link or brand and part number for the crossover fuel line that was used? Thank you.

[@motortopiaondemand]

I made my crossover kit with the left over fuel lines from the Boyd Welding fuel cell kit and -6AN fittings.

[@JT-gw9gz]

Hi, thanks for the great video, question: Can that setup be used to convert a carburated mercruiser 502 to EFI? I am looking for more power, but also better fuel economy

[@motortopiaondemand]

This setup would not work for that but you could look at Holley's sniper system that would be perfect for an EFI conversion.

[@fernandodelavara4577]

Where did you get the block off that go behind the fuel rail?

[@motortopiaondemand]

These fuel rails are machined to take a -8AN fitting so we used -8AN plug

[@Ls3leroy]

What fittings did you use on the fuel rails ?did you use a 6 an crossover tube?

[@motortopiaondemand]

We used all AN fittings for the fuel system and made a crossover line out of a some -6 AN 90s and fuel line left over from the fuel tank install.

[@LoperLoper-mt2wu]

Hi I'm just trying to figure out what size injectors y'all used on this Holly to make it work

[@motortopiaondemand]

The link to the injectors is in the description.

[@edwindrifts7013]

Hey can you give some recommendation for 42pound injectors that fit this hi ram intake?

[@motortopiaondemand]

Yes, there's a link in the description with the injectors used with this intake.

[@thedoraiba8109]

did you need to get the high ram adapters for the injectors? or was it direct fit?

[@motortopiaondemand]

This was a direct fit with the Holley fuel rails.

[@stuartrodriguez3449]

So can you run this set up n/a for a while then as turbo in the future?

[@motortopiaondemand]

Yes. Once we get the turbo setup we can swap the intake upper and throttle body for Holley's 105mm setup and the injectors should handle the increased power.

[@chidozperformance5560]

what part # for injecters

[@floridamortgagedude]

There's a link in the description