GE Washer Diagnostic mode

Recorded: 3/22/2023
Thanks to Maytag Machine Maniac for the video I have watched earlier on his GE GTW680 washer video. So I found my ways to enter the testing mode on this machine, and it worked perfectly good! It has 26 test modes on this machine. Hope you liked it.
(Update: GE Ultrafresh is no longer serviced and replaced to Maytag MHW5630HC in June 2023)
©Ryan’s Washer Videos 2023

[@aidanalmeida]

Thanks Ryan. Glad about it.

[@Dylan-c4w1b]

Damn that gasket has seen better days

[@ArtyomEryomin]

Good, you're testing!

[@AlyssaTheWasherLover1219]

Melissa: "My Boss Likes To Mess With Me While I'm In Diagnostic Mode"

[@jlj8718]

Hi there,
Hey I replace the drum in one GE 24inch washer and after the new drum installed the machine is not working, door lock latches but does not start, I check all electrical connections and everything looks fine, somebody told that it might be the actuator or the main board, let me know if you have experience that issue with GE front load washing machines
Thanks

[@isaiahgreenfield2037]

Can you please show the buzzer goes off this Maytag commercial dryer

[@thomasmartin4087]

I cannot get my washer to pump or drain the same one you have

[@ChristianWoods-i6z]

Any tips on leaking washer from bottom? Gaskets been replaced as well as pump 😮

[@NateHall-bj3rx]

What about the door boot?

[@brettrice6383]

any advice #14 #26 mine spins for 5-6 seconds

[@mikeschulte4271]

What does that stop sign say on ur wall? Is it a warning about something?

[@thomasmartin4087]

OK I’m not getting no action for none of my rinse or locks or anything we cannot be

[@rhondapage7798]

That little squeak sound….what is that? Ours does that and it’s under 5 years old

[@TonyRodriguez-mx4tw]

We have that same sqeak noise but continues for a few seconds when water is entering unit then stops. What’s that about?