My Daughter has a very similar pitbike,she was a little Ninja no fear.This content reminded me of the best time in my life father & child hanging together.Clear diction grammar well presented video,Good on you Mate.
Hi I Been watching you for about 3 and a half months now you might not reply but I was wondering I bought the same carb because of you 💪🏾 and I wanted to know can you give me the link to the mount you used for the carb because mines doesn’t fit
Thank you for the video. I recently bought this carb, but the carb did not come with the advertised stock jets installed. According to their print out, there should have been a 105 main jet installed, but instead there was a 108 installed with no 105 not even as an extra. pilot was 40. Can you tell me what size main jet you are running in the video? Thank you again.
Did you have to cut anything to get the carb to mount and fit under the frame? Didn’t you have to cut the last Nibbi carb you put on in a previous video?
When buying this carb, do you recommend any rubber gaskets that some of the knock off Mikuni‘s come with or any extra jets to get this tuned in easier?
For th life of me I can not get my Nibbi 26mm jetted right on my YCF Pilot 150... my bike came stock with air box an a Nibbi 19mm which is too small for a 150cc engine an not allowing for full potential power... that's why I purchased a 26mm Nibbi.. been fighting this carb for over a month now.. just wish I could get it tuned right so I can ride.. because im.at hw end of my rope an pretty much have no other choice but o put the 19mm back on the bike..
@@throttlefamily4655 yes i have, watched quite a few times incase I may have missed something.. I have been all the way up to a 55 pilot an all the way down to at 32 pilot, an I still have the bog off idle.. now I have gotten it tuned to where it's running good an bike pulled hard with a very slight sputter if I let off the throttle for a second or 2 an back to full throttle.. plug an my exhaust melting my rear fender an number plate some.. that was with a 48 pilot 105 main, needle up 1 postion an 2 turns out from factory setting.. I have no air leak by airbox rubber boot, carb intake or on exhaust side.. I checked the float, an it's in correct postion.. And as far as the airbox being the issue instead of pod filter, seen a few other guys running Nibbi 24mm an 26mm with no problems.. P.S. I'm located in South East Louisiana at 6 ft below seas level an humidity is always high down here if that matters any.. those guy or located upper states..
I was curious if you had any input on these ssr’s vs the piranha bikes? I know the latter are better equipped and have the price premium for that. Given suspension and upgrades for an adult to the ssr. TIA!
I really like the piranha pit bikes but for the price you can get a ssr for it’s hard to compare them I spent about $120 and completely swapped my rear shock and put spacers in my front forks if I was hitting big jumps I would need to swap out the front but the jumps I hit right it handles fine. I will say maybe one day I’ll do the front fork upgrade
Gd video. I've got an early ssr 125. Pd 100.00 for it a few months ago. Picked away at needed repairs and runs decent thanks in part to you. I like the idea of 24mm over 26mm carb. So Thank you and the Lil fella for doing the R&D. Big Love to all. Stay healthy. Ride hard. 🧂 🧂 🧂
That is Awsome! I definitely love riding my pit bike and I want it to run as good as possible. These bikes are really great the main part is making sure all the bolts have lock tight and you keep up on the maintenance. Have fun riding
Got the carburetors today wow your are right great craftsmanship attention to detail nice finishe and packaging to I followed you for the knock off mikuni now following you again with this nibbi let's see did you also replace the main jet or just the pilot from 40 to a 35 also added the Teflon bushings on the front forks and replace the fork oil with maxima 20wt you have try it thanks for your videos and tip and inspiring people to the sport
@@blackwater.performance7294 you are very welcome we are excited to get back to youtube and make more content! I love riding dirt bikes and now my son has been begging for a new one so now we are going to have another member that will be on the Channel more! This new carburetor works great right after I dialed it in I was super excited
@@TheManCaveMetalFab2580 we are coming back we took a year to get the shop ready and get money together for new projects we have been filming for the past two months so we can stay on top of trying to do one video a week I also took a film / editing class so hopefully we can make much better videos
@@throttlefamily4655 thanks for the reply man! So I’m still missing my air filter, and I still get bog when I pull throttle fast, I already changed out the 40 to a 35 jet and put needle on second from bottom, seems to not bog as bad when fuel screw is set to about 1 1/2 out and idle screw is set somewhat high, but I feel like my idle is a bit high. Any thought? Can make the missing air filter cause that? I have bo bike knowledge this is my first carb pit bike , and it’s a semi auto for my wife which I need to bleed the brakes cuz if I put her in gear she’ll take off and pop a wheelie , TIA
@@jessemannygallegos4629 it is probably because you don’t have an air filter probably getting too much air too fast the bike should idle no problems low what elevation are you?
@@throttlefamily4655 I’m about 1500 feet, what air filter to you recommend? I will be riding in dirt a lot, and what size is that nibbi 24mm appropriate filter ? Thanks!
My Daughter has a very similar pitbike,she was a little Ninja no fear.This content reminded me of the best time in my life father & child hanging together.Clear diction grammar well presented video,Good on you Mate.
I'm really happy I found you my guy. I have a apollo 125cc and didn't know much about it. But these videos have helped a lot
Great info even better bloopers.
Hi I Been watching you for about 3 and a half months now you might not reply but I was wondering I bought the same carb because of you 💪🏾 and I wanted to know can you give me the link to the mount you used for the carb because mines doesn’t fit
Can I use this on a 110 pit bike?
What spark plug do you use
Is this carb still working good for you or did you switch back to a old one?
Thank you for the video. I recently bought this carb, but the carb did not come with the advertised stock jets installed. According to their print out, there should have been a 105 main jet installed, but instead there was a 108 installed with no 105 not even as an extra. pilot was 40. Can you tell me what size main jet you are running in the video? Thank you again.
How do I buy one
Air filter your using with it ?
I was using a uni style one at first but then switched over to my nibbi cone filter I had
Did you have to cut anything to get the carb to mount and fit under the frame? Didn’t you have to cut the last Nibbi carb you put on in a previous video?
When buying this carb, do you recommend any rubber gaskets that some of the knock off Mikuni‘s come with or any extra jets to get this tuned in easier?
For th life of me I can not get my Nibbi 26mm jetted right on my YCF Pilot 150... my bike came stock with air box an a Nibbi 19mm which is too small for a 150cc engine an not allowing for full potential power... that's why I purchased a 26mm Nibbi.. been fighting this carb for over a month now.. just wish I could get it tuned right so I can ride.. because im.at hw end of my rope an pretty much have no other choice but o put the 19mm back on the bike..
Have you watched my how to tune video?
@@throttlefamily4655 yes i have, watched quite a few times incase I may have missed something.. I have been all the way up to a 55 pilot an all the way down to at 32 pilot, an I still have the bog off idle.. now I have gotten it tuned to where it's running good an bike pulled hard with a very slight sputter if I let off the throttle for a second or 2 an back to full throttle.. plug an my exhaust melting my rear fender an number plate some.. that was with a 48 pilot 105 main, needle up 1 postion an 2 turns out from factory setting.. I have no air leak by airbox rubber boot, carb intake or on exhaust side.. I checked the float, an it's in correct postion.. And as far as the airbox being the issue instead of pod filter, seen a few other guys running Nibbi 24mm an 26mm with no problems..
P.S. I'm located in South East Louisiana at 6 ft below seas level an humidity is always high down here if that matters any.. those guy or located upper states..
I was curious if you had any input on these ssr’s vs the piranha bikes? I know the latter are better equipped and have the price premium for that. Given suspension and upgrades for an adult to the ssr. TIA!
I really like the piranha pit bikes but for the price you can get a ssr for it’s hard to compare them I spent about $120 and completely swapped my rear shock and put spacers in my front forks if I was hitting big jumps I would need to swap out the front but the jumps I hit right it handles fine. I will say maybe one day I’ll do the front fork upgrade
Gd video. I've got an early ssr 125. Pd 100.00 for it a few months ago. Picked away at needed repairs and runs decent thanks in part to you.
I like the idea of 24mm over 26mm carb. So Thank you and the Lil fella for doing the R&D.
Big Love to all. Stay healthy. Ride hard. 🧂 🧂 🧂
That is Awsome! I definitely love riding my pit bike and I want it to run as good as possible. These bikes are really great the main part is making sure all the bolts have lock tight and you keep up on the maintenance. Have fun riding
Questions do i need to replace the stock throttle cable on my bike 2022 ssr 125 35 pilot jet those it come with the carb kit
You do not need to change your throttle cable and yes the 35 pilot does come in the kit
Thank you brother for the fast reply 👍
@@blackwater.performance7294 no problem
Got the carburetors today wow your are right great craftsmanship attention to detail nice finishe and packaging to I followed you for the knock off mikuni now following you again with this nibbi let's see did you also replace the main jet or just the pilot from 40 to a 35 also added the Teflon bushings on the front forks and replace the fork oil with maxima 20wt you have try it thanks for your videos and tip and inspiring people to the sport
@@blackwater.performance7294 you are very welcome we are excited to get back to youtube and make more content! I love riding dirt bikes and now my son has been begging for a new one so now we are going to have another member that will be on the Channel more! This new carburetor works great right after I dialed it in I was super excited
Love the videos. Real close to getting the SSR 170. Any thoughts on the bike? Or specific carburetors that would make it run better? Thanks!
Hello for a 125cc pit bike should I buy a 22mm or 24mm carb? Or biger?? Thank you
Id go 22mm for 125cc they are the most compatible
Tried my best to convince my parents to get a pit bike after we sold our jet skis. Didn’t work and kinda upset. Was gonna get ssr 125
Well show them our videos and if that doesn’t work we will be giving away a pit bike soon!
What elevation are you guys at?
3200
@@throttlefamily4655 I was looking at your guises videos and from what I can tell your last one was a year ago are you guys posting anymore??
@@TheManCaveMetalFab2580 we are coming back we took a year to get the shop ready and get money together for new projects we have been filming for the past two months so we can stay on top of trying to do one video a week I also took a film / editing class so hopefully we can make much better videos
@@throttlefamily4655 sweet that’s good news. I was afraid something bad happened. I’m glad that you guys are still doing UA-cam.!!😀
@@TheManCaveMetalFab2580 ohh yea we are so fired up we should have some very good content coming!
Just found out the people who sold me my SSR did not put a new gasket on when they rubuilt the carb. Does this carb come with 2 gaskets ?
No but I know you can pick them up really cheap this one comes with the the o- gasket so you don’t need one up top
@@throttlefamily4655 Cool.. what size carburetor did you order for your model?
@@MrMinecraft1445 I got a 24mm
Did you happen to find a gasket kit for this? I’m looking too!
@@joneades3204 Yes. You might need to get one specifically for your carb though. You might have a bigger or smaller gasket so be precise.
Do you have the vid of you installing this?
Best Pit Bike Power Upgrade for only $35 !!!
ua-cam.com/video/hRbwQfnMwXQ/v-deo.html
Here you go this is a video of me installing a very similar one so all the steps are the same
@@throttlefamily4655 thanks for the reply man! So I’m still missing my air filter, and I still get bog when I pull throttle fast, I already changed out the 40 to a 35 jet and put needle on second from bottom, seems to not bog as bad when fuel screw is set to about 1 1/2 out and idle screw is set somewhat high, but I feel like my idle is a bit high. Any thought? Can make the missing air filter cause that? I have bo bike knowledge this is my first carb pit bike , and it’s a semi auto for my wife which I need to bleed the brakes cuz if I put her in gear she’ll take off and pop a wheelie , TIA
@@jessemannygallegos4629 it is probably because you don’t have an air filter probably getting too much air too fast the bike should idle no problems low what elevation are you?
@@throttlefamily4655 I’m about 1500 feet, what air filter to you recommend? I will be riding in dirt a lot, and what size is that nibbi 24mm appropriate filter ? Thanks!
Hey bro … I have an xpro storm 125cc… wat carb size should I get… the normal 22mm or the 24mm
I hear ppl say the vm22. Did you find anything out on this?
You moved the clip on the "Jet Needle", not the needle jet. the needle jet is the tube that sticks into the venturi!
Bought an ssr150 the carb is sooooooo bad man.
Bike feels like it’s drowning
Def getting a new carb📝
This is the best one I have tried so far definitely worth the money! I’m very happy with it
Vm26 for me.
Who ever is early and reading this I hope you are having a wonderful day