Range Rover L322 Glove Box Assy removal

This video is about Range Rover L322 Glove Box Assy removal

[@brianevans673]

Brilliant video! The editing was the best part, thanks for not making us sit through every screw that was removed!

[@gary2turbos]

Hi Brian, Thanks very much for your positive comments, hope it was useful 🙂👍🏻

[@philipgrice1026]

Thank you for the video. It was very helpful, I found two challenges that occurred during the removal of the glove box.
The first was getting the air vent out of the dash. Those four simple plastic spring clips are hard to get to on one side and all four must be pulled out before the vent will come out. All four clips in my RR would spring back as soon as released. It required monkeying around with fine steel rods to get all four held out of the way requiring two pairs of hands where only a few fingers will fit, Much cursing ensued.
The other challenge was the two screws that hold the glove box lock in place. Yes, they are awkward to get at. So awkward that they had been installed with stripped Torx sockets. I had to drill the blighters out! That was PITA.
All this just to remove two screws in a stupid place. They are never going back in my car!

[@warwickbunn1250]

Thanks for the great video. Nice and detailed.
I think I need to get to one of the relays on the back of the fuse board and presume I need to get to it by removing all these bits. This is the first video I found to show me how to do it without doing damage ! So I'm very grateful. Keep the vids coming, they're great !
Thanks again.

[@gary2turbos]

Hi Thank you very much for your positive comments. I’m really pleased you found it useful. I made the video for a similar reason - I hadn’t found any videos either, so I’m really pleased it might help you out with you fix. Thanks for taking the time to comment.

[@yueibm]

Thank you! I’m removing my glovebox to get to the air conditioning TXV. Have a great day!

[@gary2turbos]

Glad it helped, you have a great day too!

[@stevenmartin3947]

Thankyou very much for making this how to video. I’ve been putting off replacing the glovebox due to mine breaking about six months ago.

[@gary2turbos]

Hope you got it sorted Steve, thanks for the comments.

[@WatchWithMeYoutube]

10 out of 10 video absolutely smashed it👍👍

[@gary2turbos]

Thank you

[@MrSteelsilver]

Great video, ive just done mine and ran into a problem, the two screws that hold on the glovebox latch kept spinning, so watched this video and found they dont need to be removed, once you slide the glovebox out, you can just unhook the cable.

[@gary2turbos]

Glad it helped thanks for watching!

[@MrSteelsilver]

@@gary2turbos at the beginning of the video, she says she wants to replace it with n iPod cable, what cable did she use? I’d like to do the same.

[@tomchillen3039]

@@MrSteelsilver I think you can just buy a generic cable with an adapter

[@2674nismo]

Awesome video thank you so much

[@yungone969]

Great video 👍👍

[@gary2turbos]

Thanks hope it helped!

[@kevinblaylock9883]

Helpful video, however when removing the corner wood panel, there is a screw that is under the top of the dash. You will not be able to remove this panel without unscrewing first. Your video shows the panel removed without this screw present. I assume yours was not in place from a previous removal or just broken and not replaced. 🙂👍

[@redemption-leadership]

Thanks for that!

[@gary2turbos]

No problem hope it helped!

[@victorgarnierastorino1799]

Dear Gary, thank you so much for your video. Unfortunately, my glove box button won't open it, any idea? At the end of the video, you remove the latch. I need to access this latch to open the glove box...Thanks for your help! V.

[@2674nismo]

How did you convert the CD changer to auxiliary input

[@gary2turbos]

Don’t think we did but should be able to buy the unit to replace the cd changer then follow the video to help you install, hope this helps!

[@staffs964]

Excellent Video... Thank you.

[@gary2turbos]

You’re welcome, glad it was useful.

[@davidlawrencebanks4610]

Thank you, very informative

[@gary2turbos]

Thanks David for your positive comments

[@oSTYNCLSYo]

Great video thank you

[@gary2turbos]

Thank you

[@jayc4721]

Great video. Out of interest what symptom were occurring when it gave up the ghost.
Regards

[@gary2turbos]

HI, the CD Cartridge/magazine was stuck in the CD changer hence I had to pull it out to lift the lid, thanks for your comments

[@powerbookg4apple]

We have a replacement cd changer to go in ours we have had our old one taken out then put back in but not screwed in as ordered the wrong changer but now we have matched the serial number with a new one wondering if the screws are no longer in how easy is it to pull out the old one and put the new one in sorry for long message it was the garage who did this wondering if we can do it ourselfs ?

[@gary2turbos]

Hi you should easily be able to do it yourself if you have the tools featured in the video - good luck

[@powerbookg4apple]

Gary Smith that’s I slipped the old one out and plugged the new one in works a treat not bad for £26 all in a lot cheaper than buying a new one

[@jaerod1982]

Amazon video !! But did you find a way to connect a iPod, aux ? Anything lol ? I have seen a kit that requires to install by taking cd changer out it’s why I wanted to know before I proceed taking that off and it might not work, cause my cd changer is not working properly

[@gary2turbos]

Hi thanks for your comments. I did buy a lead for a X5 but found it was the wrong pin connection. I didn’t proceed to finding the right lead but I believe they are available.

[@johnriley140]

Do I need to remove the box to get to the relays

[@gary2turbos]

It depends which relay box you’re trying to get access to John, I believe there are some behind the glove box.

[@bouncefan]

Have you got images or video of rear of cd changer and or cables great video going to have to do all this on mother in laws range

[@gary2turbos]

adam roberts Hi thanks for your comment and apologies for the slight delay in responding , I have a picture of the connector , the mechanism in the CD changer and he footwell with everything dropped out if that helps? If this would be any use drop me an email address or similar. Thanks

[@bouncefan]

@@gary2turbos brilliant [e-mail]

[@gary2turbos]

@@bouncefan Sorry I didn’t respond to you in good time, hope you got it sorted

[@bouncefan]

@@gary2turbos had taken it out in the end but no closer to replacing don't suppose you know if it's like for like or is there other options

[@gary2turbos]

@@bouncefan if you are going to replace it with another cd changer there might be an option from a X5 but I suspect they may be different connectors. It might also vary depending on what year you have (not sure if RR changed around 2005 or not) - if you’ve not tried already you could try some of the L322 forums, there’s normally a lot of info on them. Sorry we can’t be of more help.

[@stevenmckinlay4478]

Ridiculous

[@gary2turbos]

Yes I thought the video was ridiculously good too thanks

[@stevenmckinlay4478]

@@gary2turbos ridiculous amount of work tk remove the glove box.
But I appreciate your reply....

[@stevenmckinlay4478]

@@gary2turbos I was going to remove the glove box just now but after watching that amount of work, I'm leaving it until tomorrow.

[@gary2turbos]

@@stevenmckinlay4478 at least this should save you more ridiculous work to do the job ;)

[@stevenmckinlay4478]

@@gary2turbos certainly will, and much appreciated. My initial comment was regarding the ridiculous amount of work tk remove the glove box. No insult intended.
After watching I would have broken something no doubt.