05 to 09 Mustang Ignition Switch Replacement (car alarm issues)

Поділитися
Вставка
  • Опубліковано 22 сер 2024
  • In this video, I replace the ignition switch on a 2008 Mustang 4.0. These instructions will work on all 05 to 09 Mustangs. I replaced the ignition switch because the car alarm kept going off and the ECM stated the ignition switch was defective.
    Part Used in the Video:
    www.autozone.c...

КОМЕНТАРІ • 15

  • @rickpowers4356
    @rickpowers4356 Рік тому +1

    Thanks for posting this video. It was very timely for me because my ignition switch started acting up about three weeks ago. I followed your instructions which were very helpful. However, I found my car had the console top sealed down at the factory by melting plastic tabs underneath the door hinge. I was finally able to get to the switch after partially removing the lower dash and also taking out the kick panel and sill plate. Thanks again for your advice. I don’t think I could’ve figured it out on my own.

  • @dk8460
    @dk8460 9 місяців тому +2

    You moving the camera too much…nobody can see what you’re doing

  • @mustangaddict589
    @mustangaddict589 10 місяців тому

    How can you tell if there bad, swapped engines an now no start at all does nothing when turning key

    • @chasingmustangs
      @chasingmustangs  10 місяців тому

      You will get an engine code if bad. If you don't have a reader, I think autozone loans them out. The best place to start is connecting a scanning and reviewing any error codes.

    • @mustangaddict589
      @mustangaddict589 10 місяців тому

      @@chasingmustangs interesting Ty for your response after inspecting looks like car is blowing 30 amp fuse soon as I turn the key. It’s for starter also.

    • @chasingmustangs
      @chasingmustangs  10 місяців тому

      @mustangaddict589 Check your starter cable. Make sure the nut is not corroded or missing.

    • @mustangaddict589
      @mustangaddict589 10 місяців тому

      @@chasingmustangs ok will carry on with it tomorrow

  • @johnnyacosta7551
    @johnnyacosta7551 4 місяці тому

    It would nice if you showed the part and actually placed the camera where we can see what you are doing

  • @truexkev2737
    @truexkev2737 Рік тому

    I like watching your videos very nicely detailed. I am having a issue on my 302 ho when warmed up starts back firing here n there not frequently. Any thoughts ? Appreciate the content you have for us.

    • @chasingmustangs
      @chasingmustangs  Рік тому +1

      What year Mustang?

    • @truexkev2737
      @truexkev2737 Рік тому

      @@chasingmustangs 94 sn

    • @truexkev2737
      @truexkev2737 Рік тому

      @@chasingmustangs recently had it rebuild not sure if mechanic tightened valves so much but I hear a tick as well

    • @chasingmustangs
      @chasingmustangs  Рік тому +1

      @truexkev2737 I would take it back to the mechanic. What you are describing could be bad valve seats as well.

  • @xGoku4_
    @xGoku4_ 10 місяців тому

    💯

  • @Vivianauxito
    @Vivianauxito Рік тому

    Hey,mate. Just reached out to you via email for inquiring an opportunity of Auto LED lighting review. Hope hear from you soon