Vaillant Ecotec Plus fan change

DISCLAIMER:
This video is only intended for use by qualified Gas Safe Registered engineers. You must not attempt any work on your boiler if you are not qualified. You must always carry out 26.9 checks upon completion of works on a boiler.

[@haroonali9018]

Keep the vids coming

[@yensabi]

Nice one...👍

[@jasonbrooksbank]

Had this today ordered part changing it tomorrow and pressures gauge.

[@cputilitysolutions]

Nice one, yeah it's pretty straightforward. With the pressure gauge I hope it's the one that goes into the new plastic part and not into the copper tube as that always snaps!

[@karimkhellat4491]

Real OG E

[@taz1058]

what if after replacing the fan, pcb, electrodes and ignition cable it still gives F28?

[@rosco4659]

I thought my blower needed changing but I haven't seen any fault codes come up. CH pump runs but the blower doesn't come on.

[@kevincaniot890]

Hello I have the same error do you think it is from the fan, it is not spinning

[@michaelwaring1094]

Would be a good video if you could actually see what your doing

[@dangas6422]

What tools is for screw on fan

[@cputilitysolutions]

Just a T30 and PZ2

[@MrMagsimus]

If u took this much trouble to shoot the video then it should be worth to demonstrate a bit better and clearer . Would have done justice to your video, but thanks the same 👍

[@cputilitysolutions]

Thanks 👍🏽

[@Connor-ts8mk]

Literally couldn't make it more clear mate really informative video, only fast bits were undoing the screws sure you don't need help with that 😂