TRX4M - Custom Injora IR40 Build Overview
Вставка
- Опубліковано 6 вер 2024
- Here is the full breakdown of my custom build/heavily upgraded TRX4m.
Full parts list for this build (excluding the original TRX4m Bronco that it started life as) is shown below.
As an Amazon Associate I earn a commission from qualifying purchases.
#IR40
Tyres - www.injora.com...
Wheels - www.injora.com...
Wheel weights - www.injora.com...
Axles - www.injora.com...
Links - amzn.to/497OV7t
Sliders - www.thingivers...
Shocks - www.injora.com...
Chassis Rails - www.injora.com...
Servo - www.injora.com...
Gears - www.injora.com...
Battery - www.hobbyrc.co...
ESC - www.injora.com...
Fuel Cell - www.thingivers...
Brass Knuckles - amzn.to/497qjvu
Any Comments, questions or suggestions please add them the comments section below.
That truck looks SO good.
Your videos are like a special treat. Not frequently or regularly enjoyed, but always appreciated.
Thanks man, that means a lot. I’m aiming for at least one per month, with a few shorts thrown in for good measure. 🤙
I moved the servo to the back of the servo mount
thank you very much for the sliders! exactly what i was looking for
You are most welcome! 🤙
Good job once again Phil personally I really like how your doing things.
Your keeping things interesting without it being tedious so keep it up for me mate .
I particularly liked the Phil from the future bit 👍👍
Thanks Geoff. That’s good to hear. 🤙
Very nice video, thank you for that. Try to move the servo back so you screw it in from behind. I think you servo is sitting too far towards the print end.
Maybe that it not possible with 11kg. My 7kg just fits.
Hey phil . You ok . Been a while since you posted
I also purchased this universal chassis for ir40 build, and I don’t like it. I couldn’t properly fit vertical servo in it, it catches the frame. And I don’t like how high the body stays on this chassis, supposed to be lcg. I’m gonna modify the defender lcg chassis for ir40
Wonder if you can swap the grill out to make it look like a jeep truck?
I’ve not seen one for sale, but a bit of 3d printing would make it possible for sure.
Fab vid thanks phil
Thanks Dan. 🤙
Don't use those brass knuckles you lose steering angle and binds at full lock with risk of servo damage
That’s exactly what I found. Although I managed to solve it with a jewellery file though. 🤙
Nice job
Thank you.
I can’t stand people that just flat their lips….. shocks don’t have oil in them! Sounds like you been running without oil 😂😂😂😂😂
Sorry, not quite sure I understand what you are trying to say here. Could you please explain? The shocks on this have 30cst oil in them, it is a little thin IMO so I'll be swapping it out for a heavier oil at some point soon.