RMSTATOR Polaris Sportsman 700 800 Twin EFI MAP Sensor Install

Поділитися
Вставка
  • Опубліковано 5 вер 2024

КОМЕНТАРІ • 10

  • @Tylerfixit
    @Tylerfixit 7 місяців тому +3

    Did you really just remove the snorkel screws when there are clips holding it the cover on🤣

  • @rzl07375
    @rzl07375 3 роки тому +2

    Wow big help with these vids, thanks from.an 800 pwner.

  • @meomy009
    @meomy009 3 роки тому +2

    So I see you put a new pigtail on I don't have the end and the color wires I have is red,red white,purple,orange can you take some pics of how your wiring matches the tail ?

  • @alexjurek6011
    @alexjurek6011 3 місяці тому

    Isn’t that the mass air flow..?

  • @ChrisMikkelson-ms6gl
    @ChrisMikkelson-ms6gl 10 місяців тому

    Any idea if this could cause code 21, "loss of synchronization" on a 09 sportsman 800 HO? I've been battling an intermittent issue for that for a couple years. Basically the engine has no power and is forced into a limp mode to protect the engine from being damaged.

  • @timgoddard7242
    @timgoddard7242 2 роки тому

    Any chance I can get a part # for that map sensor? 2003 Polaris 800.
    Polaris dealer told me they don't make or carry them.
    Thanks greatly appreciate it.

  • @mattmcknight3192
    @mattmcknight3192 3 роки тому

    so my 800 is throwing a code 957 and cant figure out what it mean s

  • @208films6
    @208films6 3 роки тому

    Hey i have a question i have the same quad in the video just 2 years newer and 4wd i bought it apart and the only thing that is stoping me from starting it is that i can not seem to find were the negative battery cable goes

    • @Jesse58761
      @Jesse58761 2 роки тому

      There is one for the winch that typically runs from the fron to the back on throttle side… the typical ground is short running from negative on battery over to the front brake side about a foot or so