Beginner Rotary Laser Engraving Tutorial - Calculate Steps Per Rotation Thunder Laser Rotoboss Jr
Вставка
- Опубліковано 26 сер 2024
- Do you want to start making tumblers but don't know how to get started? Today I'm walking through how to get your steps per rotation ready and all the things you need on hand to make your first tumblers.
Calculation for Steps per Rotation:
New Steps = Old Steps / measured length * intended length.
e.g.: You want to cut 100mm but get 105mm (meaning your current steps are too high) and your current steps are 200:New Steps = 200 / 105 * 100 = 190.476190
Want to dive deep into learning your laser or need some one-on-one coaching?
Learn more about my course: thingskatiemak...
* Amazon links to products I use: www.amazon.com...
SUBSCRIBE to this channel so you don't miss any new content!: www.youtube.co...
I participate in various affiliate programs. Some links that I share may provide me a small commission if you make a purchase. This is at zero cost to you. I only recommend products I use personally!
CONNECT WITH ME:
Instagram: / thingskatiemakes
Facebook: / thingskatiemakes
Email:katie@thingskatiemakes.com
Ready to buy your Glowforge? Save up to $500 here: bit.ly/glowfor...
Disclaimer: I am not a professional - just an everyday maker! This is what I found worked for me and my project. Yours may need a little different approach. Safety first!
FTC Disclaimer: This video was not sponsored - all opinions are genuinely my own. This post may contain affiliate links and I earn a small commission if you make a purchase after clicking on my links at no extra cost to you. Thank you for your continued support! - Навчання та стиль
Thank Katie. This video is exactly what I needed to get things squared away!
Awesome!
Always some great tips in your videos and a good job explaining calculating steps per.
Thanks Dave! Appreciate it
I just found your channel while uploading a video on my channel. You are such a good teacher....your technique, voice and demonstrations are excellent. I follow Robert Kofed as well and have spoken with him a few times. Consider me a new subscribers. Frank Jenkins, Owner, Pops Custom Signs, LLC.
Well thank you so very much! I try to give as much as I can an think about how it will make it easier for everyone to "do the darn thing" :)
Do you have a link for the tape measure you used?
don't know if this is the exact one - but very similar! amzn.to/3KrmkjK
your square you made in lightburn wasn't actually square. it was 25.4 x 28.331. You should turn the lock OFF and adjust both sides of the square to be equal. I'm assuming your steps per rotation are making up for it somehow. Thanks for the video by the way, all the Thunder videos make lots of assumptions that we know what we are doing already :)
Ha - that's funny that I did that - apologies for the slip up! Appreciate the feedback - I'm trying to be beginner friendly :)
@@ThingsKatieMakes totally, I'm a beginner and it was.much more thorough than anything else I've seen so far. I just wanted to make sure I wasn't crazy on how you measured things 😜
How did you measure your rollers?
I used the information from my manufacturer- Rotoboss provides for all the models.
I can not get it it to frame right. I have followed the video 😂
What issue are you having?