Hey man, I have a question for you: I have coolant leak, is not too much. Nothing visible on the engine or under. I ve been told that could be inside the egr. What s your opinion on blanking the egr? F10,2013. 😊
small advice. If you are in a trouble to push solenoid back simply place the o ring first. Then insert your solenoid. You dont have to push so hard and avoid cutting your new o- ring. Mine pair worked fine I replaced these as a maintenance.
I was hoping that you would actually go through the relearning procedure. You almost got there but stopped short! I have the same tool but when I select the relearning task, it prompts me to turn off terminal 15 and terminal R. Wait for the relay to power down and turn relay 15 back on. How do you do that?
Those things really do make a difference. Like you said, I ONLY purchased German BMW parts or the American Reman. Thank God you don't have to code those things.
Hii I have an Lci e90 330i which gives terrible gas mileage around 11mpg can you help me out with it there is zero error found don't know what's it or is it like that what should be the expected mileage please help me out 🙏🏼
Bonjours BMW DOCTOR Je possède un E60 2006 530i Ma valise diagnostic me dit : default 2A85 vanos activation coté sortie Intermittent J’ai nettoyé les electrovanes Remis en place le tous! Mais j’ai toujours le voyant moteur d’allumer ! Et mon régime moteur est bizarre quand j’accélère !
I have the same engine, idle jump between 1500 and 1600rpm at cold start goes away when warm. Have checked for vacuum leaks and nothing. Can vanos cause this?
Consider a faulty fuel injector O-ring to be leaking fuel into the cylinder after you park. Next time you start the car, the excess fuel will burn off and cause high idle. Pop the oil cap off and smell for any detection of fuel as that would indicate the fuel injector leaking fuel past the cylinder and into the crank case. check your fuel trims with a scan tool and see if you're running rich.
Excellent video explanations, but it would help the viewer if your first finger instead of the middle "bird-flipping" finger was used selecting categories on the scanner. This will allow the viewer to see the actual category selected on the scanner being pushed, especially for U.S. viewers who have to rewind constantly to understand the full meaning of each sentence spoken. If we actually saw the category selected it would help on rewinding the video, because the bird-flipping finger and hand blocks the view of the selection pushed on the scanner. This is not a put down to BMW Doctor, rather it is just the opposite with recommendations to help BMW Doctor help us viewers. Thank you for helping me personally repair as n eeded my 2011 BMW X5 i-drive 50i.
Click here to buy the scan tool used in my video amzn.to/3AhCzgh
OK.👍.
@@BMWDoctor sir how do I get ahold of you in from SA 🇿🇦?
2014/15 F20 116I with Idle issues 😭
@@Sanz_1009where u based my guy in SA?
That explains the issue. Just swapped out a bad Vanos this week and it still felt lumpy. Clear the code and she is purring. Thanks you are a legend.
Your video's are brilliant, but your introduction was the best on UA-cam :)
I wouldn't mind if you brought it back.
Viewer since 2020*
Luh u doc 🤘❤️
LEGEND.🌟.
Hi iv got a problem after replacing seals on the solinoids
Iv got
A
2a83 code
Is this because iv not reset adaptations on ecu
Hey man,
I have a question for you:
I have coolant leak, is not too much. Nothing visible on the engine or under. I ve been told that could be inside the egr.
What s your opinion on blanking the egr? F10,2013.
😊
small advice. If you are in a trouble to push solenoid back simply place the o ring first. Then insert your solenoid. You dont have to push so hard and avoid cutting your new o- ring. Mine pair worked fine I replaced these as a maintenance.
Would it cause a new soilnode not to work as I bought two from bmw but it came up with a fault code saying soilnode sticking ????
I was hoping that you would actually go through the relearning procedure. You almost got there but stopped short! I have the same tool but when I select the relearning task, it prompts me to turn off terminal 15 and terminal R. Wait for the relay to power down and turn relay 15 back on. How do you do that?
Those things really do make a difference. Like you said, I ONLY purchased German BMW parts or the American Reman. Thank God you don't have to code those things.
Hello, my N52 started to shutdown at almost any corner when revs went down. Now it wont start. Any clues.
Thanks
Hii
I have an Lci e90 330i which gives terrible gas mileage around 11mpg can you help me out with it there is zero error found don't know what's it or is it like that what should be the expected mileage please help me out 🙏🏼
Great video as usual! Are pierburg vanos solenoids any good?
Sidat is supposed to be the best next to the original ones. I have made good experience with them too. Other brands wont last long.
Bonjours BMW DOCTOR
Je possède un E60 2006 530i
Ma valise diagnostic me dit : default 2A85 vanos activation coté sortie
Intermittent
J’ai nettoyé les electrovanes
Remis en place le tous!
Mais j’ai toujours le voyant moteur d’allumer ! Et mon régime moteur est bizarre quand j’accélère !
What is code p1062 bmw 320i 2009
I have the same engine, idle jump between 1500 and 1600rpm at cold start goes away when warm. Have checked for vacuum leaks and nothing. Can vanos cause this?
@@WayToManyAssassins I have the same issue, also not sure what the issue it.
Did u scan the car for codes 🤔??
Consider a faulty fuel injector O-ring to be leaking fuel into the cylinder after you park. Next time you start the car, the excess fuel will burn off and cause high idle. Pop the oil cap off and smell for any detection of fuel as that would indicate the fuel injector leaking fuel past the cylinder and into the crank case. check your fuel trims with a scan tool and see if you're running rich.
You should run Vanos solenoid check in ista/inpa- could be out of spec but not throwing codes
The latest software version numbers are different across chassis and years
Some mechanics very tricky to repair or maintain for customers.
Not properly train.
Excellent video explanations, but it would help the viewer if your first finger instead of the middle "bird-flipping" finger was used selecting categories on the scanner. This will allow the viewer to see the actual category selected on the scanner being pushed, especially for U.S. viewers who have to rewind constantly to understand the full meaning of each sentence spoken. If we actually saw the category selected it would help on rewinding the video, because the bird-flipping finger and hand blocks the view of the selection pushed on the scanner. This is not a put down to BMW Doctor, rather it is just the opposite with recommendations to help BMW Doctor help us viewers. Thank you for helping me personally repair as n
eeded my 2011 BMW X5 i-drive 50i.
Doe the N52 engine have the rod bearing problem just like the N55 B58 S54 S55 S85 ETC?