I'll be installing my own solar system on a tile roof so my install will be a little different that yours, but I did learn from your video. Your install looks great, I like the use of the PVC to run the ground wires. I hope you answer questions from the people that reply to your videos as I'm certain that I will have some questions for you ;-0
@@paulcalif I do my best to reply, but as a small one-man band sometimes I fall a little behind. Thanks for watching and your input and I always try and share any knowledge that I have because that's what was done for me!
@@marcmandarino1853 It's s been a busy week but off the top of my head we used the Ironridge XR100 rail system/components w/ flashfoot-2 bases. Everything else is Enphases IQ8+ micros, Q-cable w/ male/female ends and terminator caps. Hope this helps and thanks for the input!
Great, great video - thank you. Question: Is it OK to install the microinverter with only 1 bolt? I ask because on an Enphase video they were using two.
@@mattkranich3964 There isn't any really good source to clarify that, there are other instructions/vids that show one bolt on the install. The bill of materials I was given from the designer/engineer of my stamped set of drawings just had 1 per micro. When torqued properly those suckers don't move, this second bolt is a little bit more labor intensive if you will, but I don't believe it's a bad idea and the bolts are cheap. Thanks for the input!
I'll be installing my own solar system on a tile roof so my install will be a little different that yours, but I did learn from your video. Your install looks great, I like the use of the PVC to run the ground wires. I hope you answer questions from the people that reply to your videos as I'm certain that I will have some questions for you ;-0
@@paulcalif I do my best to reply, but as a small one-man band sometimes I fall a little behind. Thanks for watching and your input and I always try and share any knowledge that I have because that's what was done for me!
Hey great video. Can you list your products, including the rails? Thank you for posting.
@@marcmandarino1853 It's s been a busy week but off the top of my head we used the Ironridge XR100 rail system/components w/ flashfoot-2 bases. Everything else is Enphases IQ8+ micros, Q-cable w/ male/female ends and terminator caps. Hope this helps and thanks for the input!
Great, great video - thank you. Question: Is it OK to install the microinverter with only 1 bolt? I ask because on an Enphase video they were using two.
I wondered the same thing
@@mattkranich3964 There isn't any really good source to clarify that, there are other instructions/vids that show one bolt on the install. The bill of materials I was given from the designer/engineer of my stamped set of drawings just had 1 per micro. When torqued properly those suckers don't move, this second bolt is a little bit more labor intensive if you will, but I don't believe it's a bad idea and the bolts are cheap. Thanks for the input!