Pick up my angle calculator app: Appstore: apps.apple.com/us/app/miter-angle-calculator/id1591826245 Google Play: play.google.com/store/apps/details?id=com.miterangle.miterangle&hl=en_US&gl=US
Oh this is awesome! Ok you sir are super smart! I wish I could get it to work on a full taper of 26" board. But I don't think I could cut the piece to hold it for the second taper. Any ideas?
Hi Emily, thanks for watching! You wouldn't necessarily need to cut a full length piece to fill in for the second taper. You could just cut a short length to fit under each clamp. Does that make sense? So, if you have 3 clamps like I show in the video just cut 3 pieces say, a couple of inches each, and put each one of those under each clamp. At least in my mind that would work. Thanks again for the feedback! Let me know how it goes.
Pick up my angle calculator app:
Appstore: apps.apple.com/us/app/miter-angle-calculator/id1591826245
Google Play: play.google.com/store/apps/details?id=com.miterangle.miterangle&hl=en_US&gl=US
Thanks very much for this video, very easy to follow, very informational, thanks again.
Glad it was helpful!
Thanks so much great, easy to follow video.
You're welcome!
Exactly what I needed to know. Had to search several videos to find what you were teaching here. Thank you.
Glad it was helpful!
Your jig is the most friendly and I think just as accurate and flexible. Good job!
Thanks for the feedback!
Thanks for all your videos. Im enjoying them and learning lots.
Thanks Travis. I'm learning myself and passing along what I've come up with.
Exactly what I needed. Thanks 👍😊
The is excellent. I’m enjoying your videos. Looking forward to building myself a couple of those fantastic night stands.
Glad you like them! You can build them, they're not too difficult. Thanks for the feedback.
Excellent video Ronnie! Bought the set of 4 clamps for $10 so I can make tapered legs for a small writing desk.
Awesome, sounds like a nice project.
Oh this is awesome! Ok you sir are super smart!
I wish I could get it to work on a full taper of 26" board. But I don't think I could cut the piece to hold it for the second taper. Any ideas?
Hi Emily, thanks for watching! You wouldn't necessarily need to cut a full length piece to fill in for the second taper. You could just cut a short length to fit under each clamp. Does that make sense? So, if you have 3 clamps like I show in the video just cut 3 pieces say, a couple of inches each, and put each one of those under each clamp. At least in my mind that would work. Thanks again for the feedback! Let me know how it goes.
How to make long parallèle grooves for chair or table legs..???
Quick question how did you know it was 6 degrees?
Lining the blade to the half inch mark requires about 6 degrees
@@RonniesWorkshop Ahh OK I got ya, thanks for the response I appreciate it!