07-10 Ford Expedition Water pump leak/replacement

Поділитися
Вставка
  • Опубліковано 22 жов 2024

КОМЕНТАРІ • 22

  • @mrjprice3
    @mrjprice3 Рік тому

    Thanks. I really love that process.

  • @darnellcox2779
    @darnellcox2779 Рік тому +1

    Great vid. Question. I replaced the o ring and it still leaks. Does that mean the water pump needs replacing or could there be an issue in the water pump housing

    • @AutomedicGarage
      @AutomedicGarage  Рік тому +1

      Is it coming from the weep hole?

    • @darnellcox2779
      @darnellcox2779 Рік тому

      @@AutomedicGarage to be honest I'm not sure. Only leaks while the car is not running. LoL can't lie....your video just showed me what a weep hole is

    • @darnellcox2779
      @darnellcox2779 Рік тому

      @@AutomedicGarage I thought it was coming from out of the bottom of the housing but weep hole kinda explains why I couldn't see where it was coming from

    • @AutomedicGarage
      @AutomedicGarage  Рік тому

      @@darnellcox2779 follow the trail of the leak. I would almost bet my paycheck it’s the water pump seals though.

    • @chrisoffubu
      @chrisoffubu Рік тому

      SA SA it 6

  • @adrianwysocki1086
    @adrianwysocki1086 11 місяців тому

    Hello, is it possible if you don't have a clatch tool or hammer to not remove the clutch but rather to remove the screws behind it, the one that holds the housing that covers the water pump?

    • @AutomedicGarage
      @AutomedicGarage  11 місяців тому

      Never tried it cause I think it would be a pain

  • @perez8521
    @perez8521 11 місяців тому +1

    Would this be the same for a Lincoln Navigator 09

  • @lancealderman2755
    @lancealderman2755 10 місяців тому

    Can you add coolant normally while running or is the vacuum necessary?

    • @AutomedicGarage
      @AutomedicGarage  10 місяців тому +1

      I vacuum fill to be on the safe side, these motors are bad about air pockets in the heads. If you don’t have a vacuum filler just fill and crank, run for 2-3 minutes, sit check fill if necessary. Crank again run rpm’s up to 2k for 20-30 secs turn of check full and repeat a few times and you should be good.

    • @lancealderman2755
      @lancealderman2755 10 місяців тому

      @@AutomedicGarage thanks for the
      reply!

  • @roberttristan551
    @roberttristan551 10 місяців тому

    What did you charge for that job?

  • @Dudemieser
    @Dudemieser 2 місяці тому

    I have found the best way to fix these things involves . Fire

  • @yellowcon8726
    @yellowcon8726 2 роки тому

    Good video my friend I wish you can leave rental how are you you can working on my truck