EBAY 2 POST LIFT install part 1
Вставка
- Опубліковано 8 лют 2025
- Follow my channel and subscribe for New Content
I purchased this Lift on eBay. Link below
www.ebay.com/i...
Follow me on IG: SethChurchVID
Follow me on Facebook: SethChurchVID
To Schedule Dyno Tuning services DM ME or Contact Infamous Motorsports on Facebook @InfamousMotorsports infamousmotorsports
Great video. Good looking lift. Good looking garage. Bet you're glad the guy that built it put in the 220 volt as he was doing it...LOL.
Thanks Tim
Hope you're still replying to comments here... I have this exact same lift that I'm installing. The instructions leave a lot to be desired. I'm at the point where the limit switch is installed. I cannot find the switch. Did yours come with it? Do you recall where it was? Was it loose? boxed, attached?
Also regarding the holes, I used a 3/4" bit, and while the bolts did drop right in (I have 12" thick slab) and bottom out, I also used Sika anchor adhesive (2-part epoxy from Lowes). I have lots of confidence that the bolts will hold. If only I can figure out where the limit switch is...
And finally, what did you use for fluid? I have lots of tractor hydraulic fluid, but neighbor says I should use ATF...
I was looking into buying the same lift but wasn’t sure if my garage was big enough what’s the size of ur garage cause mine look about the same
20x26
I’m 20x24 it’s just my ceiling height I’m worried about well can’t wait till you finish the install and see ur opinion on it
How tall are the walls of ur building 20x26 by how tall?
@@brentonlambert9063 115”
Why not buy a 18mm bit
does anyone know where i can find a manual for it
What did you pay for it?!
15-16 plus freight
i just bought one for $1600
@@andrewroesch1147 where did you purchased it for $1600
@@jayyee5216 eagle automotive Greensboro NC
How thick is your concrete slab?
4”
@@sethchurchvid ok I’m in Florida. Wasn’t sure if it had to be 6” thick
@@jameerchavis6135 it’s typically based on the lift itself. Some require minimum 4 others different. Consult your lift vendor prior to ordering would be my suggestion
Ew wing nuts