For anyone planning on doing this, when you twist off the locking ring to install it on the headlight, that is when you need to push the LED light through the rubber dust cover hole and then into the locking ring so that the back fan vents will be on the outside of the dust cover.
So there is another video from a different channel showing a discover and basically do everything before putting the light in and then just plop the dust cover in and then put in light after the dust cover through the hole and twist.
They don't show the part where you have to cut the rubber dust cover or the fact that the dust cover, even if you get it to fit, covers the heat sink and fan vents.
you should have used the real video output not a projector video output. we all know when its H4 high beam and low beam can't work together one must shut off
I put these on a 2003 tundra and I'm not impressed. Still see shadows and quite frankly, I don't think they are that bright. Unless someone gives up with a solution to tune/adjust these, they're going back.
These are the best they come! IV had a set on my other car for 3 years!!
For anyone planning on doing this, when you twist off the locking ring to install it on the headlight, that is when you need to push the LED light through the rubber dust cover hole and then into the locking ring so that the back fan vents will be on the outside of the dust cover.
These mfs never show the important parts of the install.
There is a part of the installation that is tricky/problematic and isn't shown in this video: the rubber dust cover.
How did you get away with the rubber dust cover installation? I have been dealing with the same problem myself.
So there is another video from a different channel showing a discover and basically do everything before putting the light in and then just plop the dust cover in and then put in light after the dust cover through the hole and twist.
@@nikilpanicker my response might help if you ever figured it out
@@FinanceMan thanks!
@@FinanceMan i am trying to figure it out I put the lights in now dust cover
They don't show the part where you have to cut the rubber dust cover or the fact that the dust cover, even if you get it to fit, covers the heat sink and fan vents.
you should have used the real video output not a projector video output. we all know when its H4 high beam and low beam can't work together one must shut off
My low beams aren't working
Did you ever get this to fix?
My low beams not working
I put these on a 2003 tundra and I'm not impressed. Still see shadows and quite frankly, I don't think they are that bright. Unless someone gives up with a solution to tune/adjust these, they're going back.