Cam/Spring Install On 6.1 Hemi
Вставка
- Опубліковано 1 жов 2024
- In this video we install a stage 2 cam and valve springs and retainers on this 2006 SRT8 300 6.1 Hemi
www.chickenhawkmotorsports.com
Come Check Us Out
ChickenHawk Motorsports
427 Mercury Blvd
Somerset KY 42503
606-416-8334
THANKS FOR WATCHING!!!
What’s the cost to have a cam and valve springs installed ??
What about the lifters???
im guessing those too... it would be retarded not to
I need to have these done to my jeep srt8 with the 6.1- wish you guys were located in CT lol- good job
Why have to remove the a/c compressor ?
What protective film is used ?
How much hp did it gain
Where are you located
Was there any Horsepower gain?
Can you run this cam with no springs?
Was their Evan any gain on the horses ??
Did you just spin cam over a couple of times to keep lifters up so you can swap cam ?
yes we always spin them and couple times and have the other cam ready to go in so as soon as one comes out the other goes right in so that way it doesn't allow time for lifters to fall
did you ever drop a lifter doing it this way? i will do mine this summer and i wont remove the heads
How’d it go
Cam specs?
This was my old Srt8 300. It’s an HHP Stage 2 rumbler cam
@@33paintrain what wheels were those
Did you just mark the timing chain and there was no need to remove the oil pump in this case? Looking into installing a drop in cam for my 5.7 but I am trying to learn how to do it myself
you dont have to pull off the oil pump if you are very careful to make sure timing chain gets back onto crank gear properly
👎