DHCP Relay-Agent Configuration in Packet Tracer Step by Step | CCNA Training | DHCP Server |

[@mikkio5371]

you are the only one who attempted to configure the server properly . weldone chief .

[@PMNetworking]

Thanks

[@VivekEntertainer]

Very well explained and it's really very easy to understand..

[@PMNetworking]

🙂

[@Bruk55sem]

wow it is an easy and good video. i hope i would buy you coffee one day. thank you sir!!

[@PMNetworking]

Thank you so much for your good words

[@vijithvishak8731]

Thanks for the video !!!

[@PMNetworking]

My pleasure!

[@ElysiaMagnus]

Thank you sir!

[@PMNetworking]

You are welcome!

[@paulsantiagovaldez5312]

Sir, what router did you used?
My question is because I cant assign IP addresses on layer 2 ports on routers, most if not all routers in packet tracer only has two layer three ethernet ports, or is there another way to enable the device to have more than two layer three interfaces? Thanks sir

[@swayampreetbehera9430]

Without apply rip protocol can we assign Dhcp relay agent?

[@PMNetworking]

Yes

[@engr.fahadiqbal7267]

My question is same.... like paul
Sir, what router did you used?
My question is because I cant assign IP addresses on layer 2 ports on routers, most if not all routers in packet tracer only has two layer three ethernet ports, or is there another way to enable the device to have more than two layer three interfaces? also you start the lecture with configured router, means if you show the configuration of routers, then it will be clear to learn. thanks

[@PMNetworking]

To configure IP address on Layer 2 port, first you need to run "no switchport" command

[@MrMayurThuruthiyil]

Good

[@PMNetworking]

Thanks for watching

[@marutipatil6399]

Adha adhura hai sab . Step by step sikhao na

[@heman89ify]

Good

[@PMNetworking]

Thanks