Do you know where to get the replacement weight disks that are under the pan? I have the 2610g model. I knocked my scale over right next to a floor vent heater and lost one or two of them down through the grating. I don't even live in that house any more. (I rented a room). I would use the scale to weigh golf heads, shafts, grips, and shaft tip weights. That way I could match the swingweight of the clubs in the set with a replacement club before I assembled the club. THANKS.
Hi need help. Series 700: Zero is ok No rubbing noticed No signs of abuse Assembly is complete 500g cal weight registers at 495g Specimen estimated at 750g Using accessory weight 500g(147.5) Problem: will not balance. Rests at max over line and rests at max below line. If pointer is manipulated to just above the line, it moves to max height, if just below line, moves to max below line. If manipulated to point on the line, randomly swings either high or low to max. All mechanical movements and bearing-plates undamaged What could be issue?
Thank you so much for posting this! Solved my problem.
Is there anything to watch for in buying a used triple beam balance?
Thank uuu ❤️
Thanks….did not see the rubber lol🤦🏾♀️
Do you know where to get the replacement weight disks that are under the pan? I have the 2610g model. I knocked my scale over right next to a floor vent heater and lost one or two of them down through the grating. I don't even live in that house any more. (I rented a room). I would use the scale to weigh golf heads, shafts, grips, and shaft tip weights. That way I could match the swingweight of the clubs in the set with a replacement club before I assembled the club. THANKS.
Hah mine had a rubber spacer under the pan.
Hi need help.
Series 700:
Zero is ok
No rubbing noticed
No signs of abuse
Assembly is complete
500g cal weight registers at 495g
Specimen estimated at 750g
Using accessory weight 500g(147.5)
Problem: will not balance. Rests at max over line and rests at max below line. If pointer is manipulated to just above the line, it moves to max height, if just below line, moves to max below line. If manipulated to point on the line, randomly swings either high or low to max.
All mechanical movements and bearing-plates undamaged
What could be issue?
Did you ever figure out your issue?
@@wakandaengineer yes, but i can not recall. I think that it had something to do with the way the weight was suspended.