Our Alarm started beeping in the night with error code 8 which would not clear. I disconnected the battery-which later tested ok at 13.7 V -and pulled the fuse on the control box to turn off all power to the unit but it still continued to chirp for quite some time -at least till I feel asleep -and then in the morning when I powered it up again it started chirping again with error 8 back again but when I cleared the error code it stopped chirping and error code 8 did not return. Any ideas as to why it would still chirp with the control Box powered off and what was going on ?
Thanks - useful video. I have a sp6000. I want to change the delay of an existing set up exterior sensor #10 to instant as there is a delay currently. I believe this is code ´08´ looking at Chapter 7 in the manual. So if I understand correctly the sequence would be: Enter-0000-010(zone)-08(zone definition)-1(partition). ? Will it ask me about the part at the end for the EOL resistors selection event thought they are already set up? Thanks
@@bradthesparky91 perfect thanks. How do I exit the programming mode without making any changes? Just want to check if the installer code hasn't been changed first. Cheers
entered Enter followed by 0000 or 000000 and the panel just emits a long beep at me and does nothing. I assume the installer has changed it then? I bet they are not willing to give it to me and I´ll have to reset everything!!@@bradthesparky91
Our Alarm started beeping in the night with error code 8 which would not clear.
I disconnected the battery-which later tested ok at 13.7 V -and pulled the fuse on the control box to turn off all power to the unit but it still continued to chirp for quite some time -at least till I feel asleep -and then in the morning when I powered it up again it started chirping again with error 8 back again but when I cleared the error code it stopped chirping and error code 8 did not return.
Any ideas as to why it would still chirp with the control Box powered off and what was going on ?
I wanna change the psw but i have 4 doors i dont remember which position is it. How to find it?
Hey Brad! What does it mean when the buttons 1, 2, 3 and stay button are flashing
Thanks - useful video. I have a sp6000. I want to change the delay of an existing set up exterior sensor #10 to instant as there is a delay currently. I believe this is code ´08´ looking at Chapter 7 in the manual. So if I understand correctly the sequence would be: Enter-0000-010(zone)-08(zone definition)-1(partition). ? Will it ask me about the part at the end for the EOL resistors selection event thought they are already set up? Thanks
it should not. it should simply work as per your statement.
@@bradthesparky91 perfect thanks. How do I exit the programming mode without making any changes? Just want to check if the installer code hasn't been changed first. Cheers
entered Enter followed by 0000 or 000000 and the panel just emits a long beep at me and does nothing. I assume the installer has changed it then? I bet they are not willing to give it to me and I´ll have to reset everything!!@@bradthesparky91
unfortunately yes you would have to reset and reprogramme the system. @@CJ-vg4tg
Paradox από τον Καναδά
Enter 0000 από το εργοστάσιο ο κωδικός