ok thank you. if you could go over what your setting were within Winlink that would be helpful. did you use kiss mode, or the drop down menue for the pk 232- frack, delay etc...put it up when you can. I have only been able to use it in kiss mode, and not the actually drop down menue for the PK-232, even though it is an option?
I was recently given a couple of PK-232MBXs. But now I'm wondering why someone would use one of these old-school hardware TNCs instead of a modern software TNC like Direwolf. Comments?
are there any special commands that need to sent to the pk232 or just turn on and operate? Also, when you setup winklink, what data rate did you setup to talk to the pk232 9600 bd ?
Very nice and explained video! 73"From Babis(Charalampos) SV1BYK
Thank you. Talk to you on DMR.
ok thank you. if you could go over what your setting were within Winlink that would be helpful. did you use kiss mode, or the drop down menue for the pk 232- frack, delay etc...put it up when you can. I have only been able to use it in kiss mode, and not the actually drop down menue for the PK-232, even though it is an option?
good video. i just hooked my 232 back up but i cant get it out of type * for auto baud routine. still working on it as of 1 3 24 any ideas
I was recently given a couple of PK-232MBXs. But now I'm wondering why someone would use one of these old-school hardware TNCs instead of a modern software TNC like Direwolf. Comments?
are there any special commands that need to sent to the pk232 or just turn on and operate?
Also, when you setup winklink, what data rate did you setup to talk to the pk232 9600 bd ?
9600 yes your right. I have taken it down but will put it up again in future
Tripod!