i'm guessing if you can connect the thread together contacts together you should be able to pull both cups in at the same time? i don't suppose it hurts to start with one cup pressed in if you already have the tools.
The outer section on one side was slightly damaged and I wasn't sure if it was a quality BB. So instead of taking it out looking at it and potentially having to wait on a delivery, I just ordered it all and did it.
what box is that on your downtube
Well done. It's always so satisfying doing the job yourself. Any problems with the BB since?
No, Still very smooth
So the non-drive-side is pressed in? I thought the two halves are pulled together by being threaded together. Is that a Wheels Mfg BB?
i'm guessing if you can connect the thread together contacts together you should be able to pull both cups in at the same time? i don't suppose it hurts to start with one cup pressed in if you already have the tools.
I pressed it to get it in square and so I wasn't having to wind the BB tool tight the whole way in, I was just easier. Yes, a Wheels Mfg BB
Hello mate, what bottom bracket tool did you use to remove it?
BB49-16 Threaded BB Removal Tool
What's the brand and model of that Bottom Bracket
WHEELS MANUFACTURING BBright Outboard ABEC-3 BB for 24 mm (Shimano) Bottom Bracket Cup Black 79 mm
Helps if your bike was more secure,instead of swinging in the wind
Yeah it would, Its a DIY job for now
Pollich Meadow
Does it fit the Cervelo S5 BBright BB
I think it does, but probably best to check
Why not just replace the cartridge bearings with Enduro/similar instead of changing the entire BB? Would have been easier and cheaper?
The outer section on one side was slightly damaged and I wasn't sure if it was a quality BB.
So instead of taking it out looking at it and potentially having to wait on a delivery, I just ordered it all and did it.
Hi what tool removal did you use
BB49-16 Threaded BB Removal Tool