I have a problem with e&c g17 gen5, the spring rod doesn't set into place and protrudes from the slide by 2-3mm. If I depress the slide release buttons slightly it clicks into place. The buttons are very stiff, is this a known issue or my unit is defective?
WE, at least in the Philippines is good for extra mags and spare parts.. I think but I'm not sure, Umarex is usually rebranded, they can be VFC, WE, etc. What I can say about E&C is that the feel is nice, also the markings on the ones I've seen and touched.
@@kellygintobias1535 makes the cycle faster. And some airsoft practical shooters disable the slide lock feature because releasing the slide takes a little bit of time, and every bit of time matters so much to them.
@@kellygintobias1535 I'll go ahead and share with you: I prefer slower and full length travel to be more pronounced on videos. And I like the lowest possible resistance to save gas. Quite the opposite of shortstroking and fast cycling. To each their own, for needs and preferences.
Wipe off the old silicone oil and gunk. Then apply new clean silicone oil. Don't use machine oil or petroleum based grease because those can melt rubber. And discolor plastic and nylon.
I have a problem with e&c g17 gen5, the spring rod doesn't set into place and protrudes from the slide by 2-3mm. If I depress the slide release buttons slightly it clicks into place. The buttons are very stiff, is this a known issue or my unit is defective?
I don't know about that issue. My best guess is that the spring guide or something on it snags on something on the frame or slide 🤷
WE , UMarex or this? Which is better GGB.
WE, at least in the Philippines is good for extra mags and spare parts.. I think but I'm not sure, Umarex is usually rebranded, they can be VFC, WE, etc. What I can say about E&C is that the feel is nice, also the markings on the ones I've seen and touched.
@@tryhardairsoft416 Ok thanks a lot.
Can anyone share what's the purpose of shortstroking or placing shock buffers?
Thanks
@@kellygintobias1535 makes the cycle faster. And some airsoft practical shooters disable the slide lock feature because releasing the slide takes a little bit of time, and every bit of time matters so much to them.
@@tryhardairsoft416 Thanks for explaining! Subscribed 🤘
@@kellygintobias1535 I'll go ahead and share with you: I prefer slower and full length travel to be more pronounced on videos. And I like the lowest possible resistance to save gas. Quite the opposite of shortstroking and fast cycling. To each their own, for needs and preferences.
What magazines are compatible with e & c glock 19 gen 3?
@@nikkomigueleustaquio5526 I honestly haven't tried compatibility with the glock. I wish I tried my cousin's WE mag in the E&C gen 5 tho
is E&C have glock 19gen 4 or gen 5 but with the entire handle without this hole for easier removal of the magazine?
I don't get your question what hole?
ya que me voy a comprar una me sirve mucho pero, como se limpian
Wipe off the old silicone oil and gunk. Then apply new clean silicone oil. Don't use machine oil or petroleum based grease because those can melt rubber. And discolor plastic and nylon.
@@tryhardairsoft416 tanks bro :D