HI,our dear users, our product does not support DIY reset or programming. Before purchasing this product, please confirm that your car has this installation position.
After installing, it works perfectly but drains the battery overnight. After removing, the battery problem has gone. Is there a solution to avoid/control car battery drain by this devise?
@@zhangcharly Thank you! It’s not draining the battery anymore. But a new problem: seems like the automatic detection is not working anymore. This is causing additional issue with the engine cylinders not receiving fuel only during start (if I press the button on the remote a few times, the engine will run normally but there will be engine failure codes recorded). Every time this happens I have to clear engine fail codes using OBD11. I’ve also tested it without this gadget (only original fuse) and it works fine with no engine failure. In short this gadget works. Just that it’s automatic detection is not working at initial start up. Any solution?
@@mazharxx Dear,friend, Most likely, your remote control is switched to manual mode. you can change it. 1. Automatic mode: Press and hold the button on the remote control for 5 seconds, the LED indicator flashes 5 times for automatic mode, and the light on the remote control flashes once for 30 seconds in this mode. In automatic mode, press the remote control light to light up. 2. Manual mode: Press and hold the button on the remote control for 5 seconds, the LED indicator will be on and then off to manual mode. In this mode, press the button on the remote control and the light will be on for 20 seconds.
Obrigado pela demonstração
HI,our dear users, our product does not support DIY reset or programming.
Before purchasing this product, please confirm that your car has this installation position.
it will last how long under the capot/inside the a lot of heat of engine and th sun?
HI , friend,this product does not have batteries and is not affected by the working environment.
De que posição de instalação esta falando, explique mais
Replace the oil pump fuse
After installing, it works perfectly but drains the battery overnight. After removing, the battery problem has gone. Is there a solution to avoid/control car battery drain by this devise?
Dear,friend,Please refer to our video to install the product. In your case, the connection should be wrong.
@@zhangcharly
Thank you! It’s not draining the battery anymore.
But a new problem: seems like the automatic detection is not working anymore. This is causing additional issue with the engine cylinders not receiving fuel only during start (if I press the button on the remote a few times, the engine will run normally but there will be engine failure codes recorded). Every time this happens I have to clear engine fail codes using OBD11.
I’ve also tested it without this gadget (only original fuse) and it works fine with no engine failure.
In short this gadget works. Just that it’s automatic detection is not working at initial start up. Any solution?
@@mazharxx Dear,friend, Most likely, your remote control is switched to manual mode. you can change it.
1. Automatic mode: Press and hold the button on the remote control for 5 seconds, the LED indicator flashes 5 times for automatic mode, and the light on the remote control flashes once for 30 seconds in this mode. In automatic mode, press the remote control light to light up.
2. Manual mode: Press and hold the button on the remote control for 5 seconds, the LED indicator will be on and then off to manual mode. In this mode, press the button on the remote control and the light will be on for 20 seconds.