Got it the fuse clamps around the fuse Were not tight enough to get good connection what i done was hanged mine upside down to move a big shop door that was heavy nuy just more of a hassle and just isr the key control to stop it instead of magnets nothing fancy here just carries the weight
When i wired mine just turning current on my led s doesnot light up and nothing work tested with a multimeter and im getting power and fuse is good would bad capacitor keep it from getting power to the leds
I found their support to be non existent. I asked about wiring a push button and got no response. For the magnets, I put the unit in neutral and pushed the gate end to the motor housing. When it got close, it would shut off the motor. If you want to see how it works without pushing the gate, open or close, just take the magnet and place it at the top or bottom half ot the motor, when it is running, and it should shut off. Look up sl600ac on youtube for videos.
I had someone install this gate opener bur did not program the remote. Can someone tell me what to do?
Hi. Did u figure out how to do it. Im struggling too
Would be nice if you could show adding a infrared sensor to this and how to wire it in.
How do you set up the magnet sensors and electrical part of it? We are really having a hard time finding some direction in it.
I haven't even been able to find a manufacture to contact anywhere in the manual?
Got it the fuse clamps around the fuse Were not tight enough to get good connection what i done was hanged mine upside down to move a big shop door that was heavy nuy just more of a hassle and just isr the key control to stop it instead of magnets nothing fancy here just carries the weight
When i wired mine just turning current on my led s doesnot light up and nothing work tested with a multimeter and im getting power and fuse is good would bad capacitor keep it from getting power to the leds
How to set up the magnets, please. That video is useless for set up the gate limits.
I found their support to be non existent. I asked about wiring a push button and got no response.
For the magnets, I put the unit in neutral and pushed the gate end to the motor housing. When it got close, it would shut off the motor. If you want to see how it works without pushing the gate, open or close, just take the magnet and place it at the top or bottom half ot the motor, when it is running, and it should shut off.
Look up sl600ac on youtube for videos.