Zener Diode Clipper Circuit : Example 1(with simulation)
Вставка
- Опубліковано 31 бер 2017
- Topics Covered:
1. How to solve clipping circuits using zener diode
2. Different bias regions of zener diode.
3. Output waveform plot.
4. Transfer Characteristics plot.
5. Simulation of the circuit
لقد كنت في حيره.... لدي امتحان ولايوجد شخص عربي قام بشرح الموضوع بدقه مثلك.. َ اشكرك انقذتني
I like your way of teaching thank you so much for your help ❤ 😊 🙏
Thanks Sir....
As always, good video . What is the name of that simulator?
@@sarath5519 what?
৪৭ নাম্বার ভিডিও টা তে দেখলাম অউতপুট ওয়েভফর্ম টা সিনোসাইডাল কিন্তু এটাতে কেন সিনোসাইডাল পেলাম না মনে হল বক্স আক্রিতির অউতপুট পাচ্ছি নাকি দেখতে ভুল হচ্ছে ?
What software do you use to simulate the circuit?
NI Multisim or Everycircuit
Brother Can you give the of the simulation software that are you used?
everycircuit
is it for free?
Is 6.2volt negative or positive for zener diode???
As 6.2V is zener voltage, it must be reverse voltage
Then my doubt is why you drawn 6.2volt in positive half cycle.. it is for negative half cycle yes or not
Please clear my bad doubt...
It is not for the negative half cycle...It is for that half cycle for which Z.D. will be in R.B. . Here, Z.D. will be in R.B. at +ve half cycle
You made a big mistake on 9:50, zener diode doesn't start conduct from 0V of input voltage!! It has some time shift (equivalent to the time when input signal reach 6,2V) in corenspondance to input voltage.
When did I say, Z.D. start conducting from 0 input voltage?? I clearly mentioned about three different bias regions of Zener diode at the beginning. However, here I focused on Z.D. clipper circuit, not any phase shifter. To get more clarity, set the circuit in Multisim and check your confusion
There shouldn't be time shifting, you're right. My mistake, sorry once again.