Mach3 USB - Ports and Pins
Вставка
- Опубліковано 27 лип 2024
- Mach3 Ports and Pins
here are the settings I use on my CNC machine, it's not 100% necessary to use my setting, use this as a guideline if needed.
XML file can be downloaded from the link below.
www.3d-what.co.za/cnc.php - Наука та технологія
Awesome as always! Looking forward to lots more content.
Hi Dave
Ill put some new related videos up from time to time.
Requests ill yry be prompt..
Thanks for taking the time to check out my videos..
Most interesting, Thank you
Hi, i watched the video and I understand that the ports and pins relay to the wiring of the controler...
But how can I find out, wich portNUMBER or pinNUMBER I have to use?
Hi
I watched the video and liked it a lot, but I have a question how to wire the spindle and the laser on the same board
Hi.
Question..
1. Does your spindle use a VFD.
2. What voltage are your PSUs.
I have help someone who runs a VFD spindle and has 24v and 12v PSUs.
@David Le Grange
psus I didn't understand what you mean, as for the spindle yes there is a vfd
But I'm working on akz250 breakout board
I mean motion card
@@cncartnet
PSU. = Power Supply Units
Ill check out the AKZ250 and ill check out the wiring and see if i can do a wiring diagram..
@David Le Grange thank you so much
I will remind you in my UA-cam channel if my problem is solved
hi. David Le, Can you help me ?I don't know why my board mach 3, output PWM only maximum is 3.2V at S24000?
Hi , Sorry for late reply,
what is the MAX spindle speed ( 24000 RPM )
what is PWM freq - config \ ports and pins \ spindle setup \ PWM base Freq = 1000 and Minimum PWM = 0
what is Spindle Pulley - config \ Spindle Pulley \ Pulley 1, Min Speed =0, Max Speed = 24000, ratio =1
are you trying to use spindle and laser ...?
if you use both spindle and laser on PWM you must add an isolation relay .
let me know .... good luck
@David Le Grange im config the same you. I only use PWM for laser. But it not work.
@@CNC-DeMen
Did you join the DCM and AVM
Is you laser 12v.
Send make and model of laser.
Also on pully set max speed to 1000
This way S1000 is 100% power.
@@ZR6DLG hi. My module laser is 24vdc.
@David Le Grange my bob mach3 red. I'm config pwm 1000 but I don't now out pwm not 10v