How to programme ET remote to Receiver
Вставка
- Опубліковано 16 сер 2021
- In this video, we go through the programming of a 4 button ET Nice remote onto
an ET Nice single-channel receiver and reset the receiver.
Chanel sponsor Rsec Security Equipment Center
website:- www.rsec.co.za
Facebook:- / rsecequipmentcentre
Instagram:- / rsecsecurity
Link to products
rsec.co.za/product-category/a...
Typical Use Case
drive.google.com/file/d/1h-MM...
Music:- June - Bobby Richards.mp3
Please comment, like, share and subscribe to the channel
Follow me on Instagram:- / nicks_nd_tricks
Follow me on Facebook:- / nicksandtricks - Наука та технологія
Thanks, needed to use all the steps described. Appreciate the time spent to make and upload.
Hi, thank you for the comment, time well spent then!!
Thanks alot really appreciate all the time and efforts 👌
Thank you for the comment, a like and sub would be appreciated
Howzit boet. Great video. Hope you can help. I have 2 of these receivers and recently got 2 new nice remotes with a new gate motor. I cannot get the nice remotes to work on these receivers. I tried clearing a receiver and start over. Cannot program the NICE, but I can program the ET remotes. Do I need new receivers, or is there another way? Cheers Philip
Thank you for the comment Philip, there is a possibility that the new remotes does not code to the older receivers and in your case they do not... You will need a new NICE receiver added to the old receiver and run them at the same time, or see if the old remotes will code to the new receiver and keep the new one going forward. Please like and sub if you like the Video, I have Super likes available as well.
@@nicksandtrickssa Hi, thanx for the reply. Im sure the new type receiver will accept old remotes, they work perfectly on my NICE gate motor.
Hello Nick my garage door doesn't want to close , it displays b
Thank you for the comment Mzolisi
Small "b" is safety beams active, do you have safety beams?
Please see video on auto close
ua-cam.com/video/W56yUv6ZB_g/v-deo.html
But instead of turning the setting on, turn it to 0, to turn it off.
If it is a Capital "P" then you have to remove all power, and hold set for 5 seconds while off and turn back on
Hi informative video.
Once I removed all remotes do I need to reprogram the remotes using the method at the beginning if the video?
Thank you for the comment. yes you program all the remotes in using that method
Pls send a video how to connect this rx1 receiver to a et500 motor pcb
Good day Abdul I will send you a diagram shortly
drive.google.com/file/d/1HOpc14ihpeVrkU7rd_bDuktFHbL_nKgl/view?usp=share_link