Bleeding the 1275 MG Midget Clutch - Birth of a Racecar (Episode 49)

Поділитися
Вставка
  • Опубліковано 21 жов 2024

КОМЕНТАРІ • 6

  • @hstempest
    @hstempest 2 роки тому +1

    Thanks so much for this. Have all the old components off, was trying to figure out how to do what you demonstrate in this video. I think you just saved several days of frustration.
    Very high quality video, which makes the process very clear!

    • @mgmidget-thebirthofaraceca4349
      @mgmidget-thebirthofaraceca4349  2 роки тому

      Glad you found it useful. The remote bleed is a male and female connector with the female soldered to the pipe and the nipple used from the slave . Can be made yourself with a pipe flaring kit. Total gamechanger! Makes bleeding the clutch easy . Good luck with yours

  • @MH-wg6bz
    @MH-wg6bz 2 роки тому +2

    The slave cylinder replacement/bleed process has got to be the most frustrating repair on the whole car. The small access hole, access to the mounting bolts, bleeding. If you can get past that process, nothing else will bother you. :)

    • @mgmidget-thebirthofaraceca4349
      @mgmidget-thebirthofaraceca4349  2 роки тому +1

      Your not wrong! ive actually gone back to it and setup a remote bleed pipe now running from the slave to the engine bay and rebled it again. Sooooooo much easier than messing about under the car. highly recommended

  • @hstempest
    @hstempest 2 роки тому +1

    So how did you run that remote bleed pipe? I'm not getting any more spry and could use a way to limit under car work, especially on the nightmare slave location.

    • @hstempest
      @hstempest 2 роки тому +1

      Never mind, found one.